Abstract:Traditional fault-tolerant strategies inevitably lead to an increase in the amplitude of the fault-tolerant current. In this paper, a new fault-tolerant control (FTC) method is proposed for single-phase open-circuit faults in a multi-operational mode dual five-phase permanent magnet (MODF-PM) motor. The proposed method takes advantage of the motor structural characteristics to keep the amplitude of the faulty stator phase currents under fault-tolerant conditions the same as that under healthy operation. Two main strategies, termed torque compensation method and flux regulation method, are proposed. On one hand, the q-axis current of the inner stator is used to compensate for the torque loss in the case of outer stator failure. On the other hand, the d-axis current is controlled to enhance the magnetic flux of the outer stator. However, in the case of inner stator failure, since the outer stator does not have the magnetization capacity, only the torque compensation method can be used. By analyzing the structure of the motor, a mathematical model is established and two current distribution modes are provided. Based on the principle of minimum copper loss, the optimal operating mode is selected. Finally, the effectiveness of the proposed method is verified through experiments.

Two Fault Tolerant Strategies for Four-Phase Permanent-Magnet Fault-Tolerant Machine

Two short-circuit fault tolerant strategies for four-phase permanent-magnet fault-tolerant machine

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Fault-Tolerant Operation for Single-Phase Open Circuit of Dual-Armature Flux-Switching Permanent Magnet Machine by Connecting Neutral Points

Fault-Tolerance Performance Analysis of a Five-Phase Permanent-Magnet Linear Synchronous Machine

A Novel Dual Permanent Magnet Fault-Tolerant Vernier Machine with Hybrid Stator Configuration

Remedy for open-circuit fault of 4-phase permanent magnet fault tolerant motor

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

Twofold Fail-Work Remedy for Reconfigurable Driver and Windings of Four-Phase Permanent Magnet Fault-Tolerant Motor System

Remedial Operations for Open- and Short-Circuit Faults of Permanent Magnet Fault Tolerant Motor.

Control strategy for a four-phase fault-tolerant permanent-magnet synchronous machine

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

Operating Principle and Performance Analysis of a Novel Stator-PM Fault Tolerant Machine

Simple fault tolerant control of dual three-phase PMSM under one phase open-circuited condition

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Single-phase Open-circuit Fault-tolerant Control for a Dual Five-phase Permanent Magnet Motor with Multi-operational Modes

Design and Analysis of a Five-Phase Permanent-Magnet Synchronous Motor for Fault-Tolerant Drive

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Fault-Tolerant Control of Dual-Three-Phase PMSM under Open-Phase Fault Based on Two-Individual Current Control