Abstract:Three-dimensional oblique microstructures of SU-8 negative thick photoresists have drawn more attention with the rapid development of inclined UV lithography technology. In this paper, a simple model based on the Fresnel diffraction theory is developed to simulate the inclined UV lithography and predict the profiles of developed oblique SU-8 structures by utilizing the paraxial approximation approach. The reflection, refraction, absorption of the SU-8 photoresists and the reflection at the wafer surface are integrally incorporated in the model to improve the accuracy. The parameters, which have significant influence on the profile quality, have been studied in simulation. Simulation results demonstrate good agreement with the experimental results, where the oblique SU-8 structures were fabricated on glass and silicon wafers. To eliminate reflected UV light at the wafer surface, Ti films were sputtered on the glass wafers, followed by wet oxidation, thus employed as an antireflection layer. By contrast, the silicon wafers were used to fabricate the oblique SU-8 structures with reflected induced patterns. This model is useful to optimize the inclined UV lithography process of SU-8 thick photoresists and improve the efficiency of the design of some micro-electro-mechanical system devices.

Curved SU-8 structure fabrication based on the acid-diffusion effect

Application of 3d Gray Mask for the Fabrication of Curved Su-8 Structures

A New Fabrication Method for 3D Multilayer Microstructure

A novel method to fabricate complex three-dimensional microstructures

Fabricating SU-8 Photoresist Microstructures with Controlled Convexity–Concavity and Curvature through Thermally Manipulating Capillary Action in Poly(dimethylsiloxane) Microholes

Fabrication of a Three-Layer SU-8 Mould with Inverted T-shaped Cavities Based on a Sacrificial Photoresist Layer Technique

A New Fabrication Process for Uniform SU-8 Thick Photoresist Structures by Simultaneously Removing Edge Bead and Air Bubbles

Simplified microfabrication technology for producing SU-8 microstructures with high aspect ratio

Integrating Process and Novel Sacrificial Layer Fabricating Technique Based on Diluted SU-8 Resist

Process Research of High Aspect Ratio Microstructure Using SU-8 Resist

Thick SU8 Microstructures Prepared by Broadband UV Lithography and the Applications in MEMS Devices

Modeling, Simulation and Experimental Verification of Inclined UV Lithography for SU-8 Negative Thick Photoresists

Fabrication of High-Aspect-ratio Microstructures Using SU8 Photoresist

Experimental Study on Ultrasonic Stress Relief for Cured SU-8 Photoresist Layer

Residual stress release for SU-8 structures by water assist ultrasonic

One-Step Mask-Based Diffraction Lithography for the Fabrication of 3D Suspended Structures

Application of ultrasonic stress relief in the fabrication of SU-8 micro structure

Patterned Microstructure Array Fabrication By Using A Novel Standing Surface Acoustic Wave Device

Scalable Shape-Controlled Fabrication of Curved Microstructures Using a Femtosecond Laser Wet-Etching Process

Free-standing SU-8 Gratings Fabricated by Sacrificial Layer-Assisted UV Curing Imprint

A novel fabrication method of embedded micro-channels by using SU-8 thick-film photoresists