Abstract:The non-destructive stress measurement method is the main trend in residual stress analysis. The ultrasonic method, which utilizes the acoustoelastic effect of the longitudinal critically refracted (LCR) wave, is one of the time-saving measurement techniques. During the practical stress measurement on a workpiece, various external factors may impact the transmission of acoustic waves and the resulting stress value. This study revealed and discussed the effects of four factors on the LCR wave: surface roughness of the examined material, temperature of the material, external mechanical vibration, and surface paint. The stress coefficient was determined by comparing the offset time of the acoustic wave with the stress measured by X-ray analyzer in the zero-stress specimens, which had undergone annealing and deep cryogenic treatment. The test results indicated that the surface roughness did not affect the transition time of the acoustic wave, but it did decrease the intensity of the signal. The increase in temperature and the transition time of the acoustic wave were in a linear relationship. Mechanical vibrations from the environment would not affect the transition time or signal intensity of the acoustic wave, whereas the application of surface paint increased the transition time. Although the effect of paint on the actual workpiece could not be easily modified during stress measurement, the ultrasonic method was still suitable for monitoring the stress of a specific position of the workpiece throughout its operational lifetime. The experiment data in this study were applied to measuring the residual stress of an aluminum ship component, and the result showed a good correspondence with X-ray stress analyzer results.

Experimental Study on Ultrasonic Stress Relief for Cured SU-8 Photoresist Layer

Research On High-Frequency Vibratory Stress Relief For Small Assembly

Residual stress release for SU-8 structures by water assist ultrasonic

Investigation on Internal Stress of SU-8 Photoresist Film

Effects of Stress on the Adhesive Behavior of Photoresist

Research on High-Frequency Vibratory Stress Relief of Small Cr12mov Quenched Specimens

Mechanism and Experimental Research on High Frequency Vibratory Stress Relief

Study on the Mechanism and Measurement of Stress of Tio2 and Sio2 Thin-Films

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Effect of in-situ ultrasonic impact treatment on residual stress of laser deposition layer

Characterization of the Polymerization of Su-8 Photoresist and Its Applications in Micro-Electro-Mechanical Systems (Mems)

The Residual Stress and Deformation Control of TC4 Thin-Walled Outer Ring Components by Ultrasonic Regulation

Ultrasonic Measurement of Stress Considering Strain Effect

Reduction of diffraction effect of UV exposure on SU-8 negative thick photoresist by air gap elimination

Investigating the Effects and Mechanisms of Thermal–Vibration-Coupled Stress Relief Treatment on Residual Stress in SiC/Al Composites

Fabricating SU-8 Photoresist Microstructures with Controlled Convexity–Concavity and Curvature through Thermally Manipulating Capillary Action in Poly(dimethylsiloxane) Microholes

Simplified microfabrication technology for producing SU-8 microstructures with high aspect ratio

Effects of factors from practical workpieces on ultrasonic LCR method stress measurement

The Residual Stress Relief and Deformation Control of Al Alloy Thin-Walled Antenna Components by Ultrasonic Regulation

Numerical simulation of the effect of ultrasonic impact treatment on welding residual stress

Mechanical Strength and Interfacial Failure Analysis of Cantilevered SU-8 Microposts