Abstract:This paper modeled the dry band formation and arcing processes on the composite insulator surface to investigate the mechanism of dry band arcing and optimize the insulator geometry. The model calculates the instantaneous electric and thermal fields before and after arc initialization by a generalized finite difference time domain (GFDTD) method. This method improves the field calculation accuracy at a high precision requirement area and reduces the computational complexity at a low precision requirement area. Heat transfer on the insulator surface is evaluated by a thermal energy balance equation to simulate a dry band formation process. Flashover experiments were conducted under contaminated conditions to verify the theoretical model. Both simulation and experiments results show that dry bands were initially formed close to high voltage (HV) and ground electrodes because the electric field and leakage current density around electrode are higher when compared to other locations along the insulator creepage distance. Three geometry factors (creepage factor, shed angle, and alternative shed ratio) were optimized when the insulator creepage distances remained the same. Fifty percent flashover voltage and average duration time from dry band generation moment to flashover were calculated to evaluate the insulator performance under contaminated conditions. This model analyzes the dry band arcing process on the insulator surface and provides detailed information for engineers in composite insulator design.

Propagation Models for Motion Processes of Long Ac Arcs on Overhead Lines

Movement simulation of long electric arc along the surface of insulator string in free air

Movement Simulation of Three-Phase Short-Circuit Arcs on Distribution Lines Based on the Coupling of Magnetic Field and Motion

DC Arc Numerical Calculations and Experimental Researches Based on the Arcing Horn Used in Over-head Line

Dynamic Characters Exploring of Flashover Arc for AC Contaminated Insulators

Movement Simulation of Three-phase Short Circuit Arcs on Distribution Lines Based on the Coupling of Magnetic Field and Motion

Motion Characteristics of Long Ac Arcs in Atmospheric Air

An Experimental Study of AC Arc Propagation over a Contaminated Surface

Modeling of Dry Band Formation and Arcing Processes on the Polluted Composite Insulator Surface

MHD Simulation of Tree-line Arc in 10kv Distribution Network

Modeling the development of low current arcs and arc resistance simulation

Breakdown Process Experiments of 110-to 500-Kv Insulator Strings under Short Tail Lightning Impulse

Simulation and Experimental Analysis of Arc Motion Characteristics in Air Circuit Breaker

Modeling of AC Arc Discharge on Insulators in Consideration of Arc Characteristic Differences Between Partial Arcs on Top and Bottom Wet-polluted Dielectric Surfaces

A new dynamic 3D FEM model of arc propagation on cap-and-pin polluted insulator to predict DC flashover voltage

Simulation Analysis of Arc-guiding Performance of Grading Rings for Composite Insulators

Simulation of Fault Arc Using Conventional Arc Models

DC Arc Self-Extinction and Dynamic Arc Model in Open-Space Condition Using a Yacob Ladder

Numerical Simulation of Arc Motion During Interruption Process of Low-Voltage Circuit Breakers

Modeling Pantograph–catenary Arcing

Study on Dynamic Flashover Model of Ice-Covered Insulator String