Abstract:The geometry of fan-shaped pollution on the surface of an insulator accounts for two different values of Salt Deposit Density (SDD), conductivity, and resistance on the leeward and windward sides of the insulator. This paper proposes a novel dynamic theory model of AC flashover based on equivalent resistance in the presence of a fan-shaped pollution layer. The proposed model can calculate flashover parameters for different values of the fan-shaped pollution density degree (T) and extension degree (J) considering instantaneous variables in arc progression. In this model, the arc current is formulated using the arc equivalent circuit for a constant arc voltage in terms of arc length propagation. Also, the Form Factor (F) is defined as a function of the arc length by sampling from the desired insulator and curve fitting. To validate the analytical model, some experiments are performed on an insulator unit of suspension porcelain by applying artificial pollution at three levels: light, medium, and heavy. Test results show that the critical flashover voltage (CFO) is reduced by 19% by varying J from 1 (uniform pollution) to 1/15. Moreover, by varying T from 10% to 30%, the CFO decreases by 9%. As the non-uniformity degree increases, the correction factor varies in the range of 0.798 ~ 0.938.The proposed modeling of flashover provided by the paper could be used to perform a dimensioning method on insulators under fan-shaped pollution conditions. Also, the proposed model can be included in the EMTP-type platforms to determine the minimum insulator flashover characteristic that will provide an adequate flashover performance under pollution conditions.

A new dynamic 3D FEM model of arc propagation on cap-and-pin polluted insulator to predict DC flashover voltage

An Improved Dynamic Multi-Arcs Modeling Approach for Pollution Flashover of Silicone Rubber Insulator

AC flashover dynamic model suggestion and insulation level selection under fan-shaped pollution

A new approach for the flashover voltage prediction using an arc propagation reproduction on a high-voltage insulator

Study on Dynamic Flashover Model of Ice-Covered Insulator String

Modeling of Dry Band Formation and Arcing Processes on the Polluted Composite Insulator Surface

Research on Improved Schwarz Arc Model Considering Dynamic Arc Length

Modeling the development of low current arcs and arc resistance simulation

Propagation Models for Motion Processes of Long Ac Arcs on Overhead Lines

Electro-thermal analysis and dynamic arc parameters evaluation in multi chamber arrester under structural and dimensional changes effect using the finite element method

Calculation of DC and AC Flashover Voltage of Polluted Insulators

Numerical Simulation on Thermal Decomposition Process of Electric Arc Fault in Epoxy Resin Impregnated Paper Bushing

A mathematical model for investigation of dry band location on 22 kV bushing with and without RTV coating: Experimental study

Simulation Study on the Influence of Electric Field on Contamination Accumulation Characteristics of Insulator

An alternative simulation approach for surface flashover in vacuum using a 1D2V continuum and kinetic model

Prediction of Pollution Flashover Voltage Based on Leakage Current under AC Operating Voltage

High-impedance arc fault modeling for distribution networks based on dynamic geometry dimension

A 2-D Axisymmetric Magneto-Hydrodynamic Model of a DC Arc Plasma Torch and Its Solution Methodology

Risk assessment of contaminated composite insulators in pre-flashover conditions

Modelling and simulation study on dynamic pollution accumulation process of composite insulator

An AC arc discharge model for ice-covered FRP live-line tools