Abstract:Gas insulated switchgear (GIS) is widely used in power system. With the increase of voltage level and substation scale, filed impulse voltage withstand test is increasingly important to ensure GIS safety as AC voltage withstand test becomes non-effective for the exposure of all defects. Standard lightning impulse (SLI) is normally adopted in factory, whereas oscillating lightning impulse (OLI) is more suitable for field use for its high generation efficiency. Thus discharge characteristics of typical defect in GIS under OLI need to be studied. Sharp protrusions on conductor are typical defects in GIS and are critical at lightning impulse voltages. This paper therefore aims to study discharge characteristics of protrusion on conductor under OLI. An impulse voltage generator was first established to generate four oscillating lightning impulses. A 12 mm long protrusion defect was then set up on conductor in a 330 kV GIS chamber. There was an ultra high frequency (UHF) sensor in the neighboring chamber to measure partial discharge (PD) and a voltage divider was used to measure applied voltage waveform. PD characteristics, 50% probability breakdown voltage (BDV50) and Voltage-time characteristics (V-t characteristics) were experimentally studied. The results show that breakdowns always occur in the vicinity of each wave peak under OLI. Obvious polarity effect exists that BDV50 is much lower for positive polarity. Wavefront has strong influence on the discharge characteristics. For positive polarity, short wavefront indicates that first streamer discharge will directly lead to breakdown. Pre-breakdown discharge is followed by breakdown when wavefront is longer, in which corona stabilization effect is observed. For negative polarity, corona stabilization effect is more obvious. Breakdowns first occur in the third oscillating period with 1.2 μs wavefront and there exists PDs in the first and second period. With 13 μs wavefront, breakdowns only occur in the first period. The results of the study are expected to provide important clues for the choosing of voltage waveform and analysis of test results in field test for GIS.

Breakdown Process Experiments of 110-to 500-Kv Insulator Strings under Short Tail Lightning Impulse

Experimental Study of Protection Measures for Preventing 10 KV Insulated Conductors from Breakage Caused by Lightning Stroke

Experimental Study and Analysis of Insulator Breakdown Characteristics with Short-tail Lightning Impulse

Experiment and Simulation of Air Gap Breakdown Characteristics Under Short-tail Impulse Waveform

Research on DC Breakdown Characteristics for the Insulation of 10 Kv AC XLPE Cables

Turn-to-turn Insulation Breakdown Characteristics under Non-Standard Lightning Impulse Voltages

Breakdown Characteristics of Oil-Paper Insulation under Lightning Impulse Waveforms with Oscillations

Partial Discharge and Breakdown of Protrusion on Conductor in GIS under Oscillating Lightning Impulses

Lightning Impulse Flashover Characteristics of Glass Insulator String with RTV Coating

The oil-paper insulation breakdown characteristics under non-standard lightning impulse voltages

Breakdown Characteristics Of Protrusion On Hv Conductor In Gis Under Oscillating And Standard Lightning Impulse Voltages

Dependence Of The Impulse Strength Of Typical Insulation Structures In Oil-Immersed Transformer On Waveshapes

“Multi-Particle-in-Series” Phenomenon and Discharge Properties Induced by Multiple Free Particles in GIS

Breakdown voltage characteristics of combined air gaps under negative lightning impulse

Breakdown Mechanism of Double Breaks in Air Under Lightning Impulse Voltage

Breakdown mechanism of RTV silicone rubber coated insulators under steep-front impulse voltage

Breakdown Characteristics of Vacuum Gaps with Geometrically Similar Structures under Lightning Impulse Voltage

Propagation Models for Motion Processes of Long Ac Arcs on Overhead Lines

Breakdown Characteristics of SF6 in Quasi-Uniform Field under Oscillating Lightning Impulse Voltages

A Model Considering Voltage Breakdown Process To Simulate Current Pause Phenomena In Electrical Wire Explosion

Numerical Model for High Voltage Insulating String Behavior