Abstract:This article presents an eight-element 17.7–19.2-GHz receiver front end with 1–2 concurrent beams in a 65-nm CMOS technology. Each output beam utilizes a temperature-compensation variable-gain amplifier (TC-VGA) to minimize the temperature-induced gain variation. The concept of the proposed TC-VGA and the realization of corresponding adaptive analog control are introduced in detail. The front-end architecture and circuit-level design to enable a flat wideband gain response, precise phase and amplitude control, low power consumption, and adaptive analog temperature compensation are presented. Wafer probing is conducted to measure the performance of the receiver front end. The measured gain-temperature coefficient is ±0.005 dB/°C from −15°C to 85 °C at 17.7–19.2 GHz, while the counterpart without temperature compensation is −0.1 dB/°C. The chip demonstrates a 28-dB power gain, a 26% 3-dB fractional bandwidth, a 3.2–4.1-dB noise figure (NF), and a −27.4-dBm input 1-dB gain compression point (IP $_{\mathrm {1\,dB}}$ ) for each element. In addition, each channel provides 7-bit phase-shifting resolution and 6-bit attenuation for a 15.75-dB gain range with a <1.5° root-mean-square (rms) phase error, and a < 0.22-dB rms amplitude error. The chip occupies $4.65\times2.77$ mm2 area with pads, equivalent to 1.61 mm2 per element (for two beams), and consumes 37.2 mW per element per beam. To the best of our knowledge, the receiver front end demonstrates the minimum gain variation with temperature among silicon RF-beamforming front ends.

An area-efficient dual-channel RF receiver for GPS-L1/Galileo-E1/Compass-B1

Reconfigurable Dual-Channel Multiband RF Receiver for GPS/Galileo/BD-2 Systems

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Low-Power High-Linearity Area-Efficient Multi-Mode Gnss Rf Receiver in 40nm Cmos

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

A low power triple-mode parallel-processing CMOS receiver for BD-II/GPS/Galileo joint navigation applications

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Four-Element 7.5–9-Ghz Phased-Array Receiver with 1–8 Simultaneously Reconfigurable Beams in 65-Nm CMOS

A 17.7–19.2-Ghz Receiver Front End with an Adaptive Analog Temperature- Compensation Scheme

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS

A GPS/Galileo Dual-module Dual-band Receiver RF Front-end Design

Design of triple-band CMOS GPS receiver RF front-end

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS