Impact of Ground Granulated Blast Furnace Slag on Calcium Leaching of Low-Heat Portland Cement Paste
Chunmeng Jiang,Li Xia,Shuangxi Li,Xiaoqing Li,Yingjie Chen,Jian Liu
DOI: https://doi.org/10.3390/ma17153857
2024-08-04
Abstract:Low-heat Portland cement and ground granulated blast furnace slag are widely used for the preparation of hydraulic concrete. Nevertheless, the effect and mechanism of corrosion on low-heat Portland cement paste mixed with ground granulated blast furnace slag need to be further explored. This paper investigated the impact of ground granulated blast furnace slag on the calcium leaching of low-heat Portland cement paste by evaluating its mass loss, porosity, leaching depth, compressive strength, and Vickers hardness, and comparing it with the leaching performance of ordinary Portland cement paste. Furthermore, the phase composition and morphology of low-heat Portland cement paste containing ground granulated blast furnace slag were analyzed by X-ray diffraction, mercury intrusion porosimetry, and scanning electron microscopy. The results indicate that, after 180 days of soaking in ammonium chloride solution, the mass loss rate, growth rate of porosity, leaching depth, and compressive strength loss rate of low-heat Portland cement paste were 8.0%, 43.6%, 9.1 mm, and 27.7%, respectively, while those of ordinary Portland cement paste were 7.4%, 37.8%, 8.4 mm, and 30.1%, indicating that low-heat Portland cement paste is slightly more damaging than ordinary Portland cement. The addition of ground granulated blast furnace slag could significantly improve the leaching resistance of low-heat Portland cement. For instance, after adding 20% ground granulated blast furnace slag, the above test values were 2.4%, 28.5%, 5.6 mm, and 20.8%, respectively. The reason for this is that ground granulated blast furnace slag has the potential to reduce the porosity of low-heat Portland cement paste, and it can also undergo the secondary hydration reaction with its hydration product Ca(OH)2 to enhance the paste structure. Considering the cost performance, the suitable dosage of low-heat Portland cement paste for satisfactory leaching resistance is about 20%.