Abstract:This study assessed the impact of calcium silicate slag (CSS), an industrial by-product of aluminum extraction from fly ash, on the reaction kinetics, compressive strength, and efflorescence of one-part sodium carbonate-activated slag (SCS). Various proportions of CSS (0%, 10%, and 20%) were used to substitute for slag. The resulting performances were evaluated through chemical shrinkage, heat liberation, compressive strength, water absorption, phase composition (XRD and TG.), microstructures (BET and BSE-EDS), and simulated efflorescence test (partially and fully immersed in deionized water). The results indicate that the CSS possesses a porous structure. The addition of CSS impairs flowability but accelerates the development of chemical shrinkage and heat liberation. The incorporation of CSS promotes the transformation of gaylussite, leading to an increase in CASH and hydrotalcite formation. Consequently, a higher compressive strength and a lower water adsorption rate are achieved. 10% CSS addition improves the splitting tensile strength of SCS under conditions of partial immersion in the efflorescence test. However, a 20% CSS substitution exacerbates the formation of efflorescence products and reduces the splitting tensile strength. These observations are associated with residual alkalis in CSS, a lower Al/Si ratio of products, and an increase in capillary pores attributed to CSS particles. This paper demonstrates the feasibility of using alkaline solid waste for slag substitution and performance regulation in SCS and reveals the underlying mechanism. The prepared CSS-SCS binder exhibits much lower energy consumption and CO2 emission than traditional cement-based material, as determined by life cycle assessment.

Influence of Classified Steel Slag with Particle Sizes Smaller Than 20 Μm on the Properties of Cement and Concrete

Understanding the Role of Calcium Silicate Slag in Sodium Carbonate-Activated Green Materials: Influence on Kinetics, Strength, and Efflorescence

Effects on the Concrete Properties of That, the Natural Sand in Concrete is Replaced by the Blast Furnace Slag

Influence of Steel Slag on Mechanical Properties and Durability of Concrete

Cementitious Properties of Super-Fine Steel Slag

Mechanical properties and durability of concrete modified with steel slag and silica fume

The influence of steel slag with high Al 2 O 3 content on the initial hydration of cement

Steel Slag/Precarbonated Steel Slag as a Partial Substitute for Portland Cement: Effect on the Mechanical Properties and Microstructure of Stabilized Soils

Influence of Steel Slag Powder on Compressive Strength and Durability of Concrete

Influence of Steel Slag on the Workability of Concrete

Recycle of steel slag as cementitious material and fine aggregate in concrete: mechanical, durability property and environmental impact

Durability and mechanical behaviors of steel slag powder concrete

Effect of steel slag powder and stone powder by-product from manufactured sand on the mechanical properties and microstructure of cementitious materials

Preparation of Sustainable and Green Cement -Based Composite Binders with High -Volume Steel Slag Powder and Ultra Fi Ne Blast Furnace Slag Powder

Experimental Study on the Concrete with Compound Admixture of Iron Tailings and Slag Powder under Low Cement Clinker System

Influence Of Steel Slag Powder On Pavement Performance And Durability Of Concrete

Influence of Ultra-Fine Slag and Silica Fume on Properties of High-Strength Concrete

Effect of blended steel slag–GBFS mineral admixture on hydration and strength of cement

Mechanical performance, microstructure, and damage model of concrete containing steel slag aggregate

Effect of Superfine Slag Powder on Cement Properties

Preparation of sustainable and green cement-based composite binders with high-volume steel slag powder and ultrafine blast furnace slag powder