Abstract:In microscale, it is hard to predict the plastic deformation behaviors because of size effects. In this study, size effects on plastic deformation behaviors in micro-compression were investigated experimentally at room temperature, including flow stress and inhomogeneous deformation. It is found that the flow stress decreases with the increase of grain size when there are more than 6.2 grains across the specimen diameter. The flow stress tends to increase when there are only 3–4 grains across the specimen diameter. Then, a flow stress size effect model considering both free surface and constrained surface effects is developed to model the flow stress size effect in microforming. The calculated results are in good agreement with experimental ones. The influence of the ratio of specimen diameter to grain size on the flow stress size effect is revealed. The experimental results also indicate that the inhomogeneous deformation in micro-compression increases with the increase of grain size. The surface folding occurs on the surfaces of some specimens with a few grains across the diameter. Then, the surface folding phenomenon is studied through Electron Backscattered Diffraction (EBSD) and the proposed model considering the microstructure distribution on the specimen surface. The reported results and models provide a basis for understanding of the size effects on plastic deformation behaviors in microforming.

Experimental Investigation on Pressure Variation During Plastic Micro-Extrusion

Exeperimental Study and Stress Analysis of Solid Granules Medium Forming New Technology

Novel severe plastic deformation method for extrusion compression composite processing

A New Approach to Investigate Real Flow Stress in Micro-Extrusion

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion

Analysis of pressure head during the process of equal channel angular pressing:experiment and simulation

Study on Micro Scale Extrusion Forging Process

Influence of injection air pressure on the microcapillary formation within extruded plastic films

Effects of Extrusion Process on Microstructure of Aluminum Profiles with Different Wall Thickness Sections

EXPERIMENTAL AND SIMULATION STUDY ON EVOLUTION OF STRESS AND STRAIN DURING THE HOLE EXPANSION

Finite Element Numerical Simulation and Analysis of Superplastic Micro-Extrusion Size Effect

Experimental Study on Effect of Thermal Deformation Parameters on Forming Process of Microgears

Study on the Size Effect and the Effect of the Friction Coefficient on the Micro-extrusion Process

Design and Implementation of the Micro-Extrusion Forming System

Effect of Holding Time on the Extrusion Force and Microstructure Evolution during the Plastic Forming of Ti-6Al-4V Micro-Gears

Study on the Extrusion Load During Equal Channel Angular Pressing

Research on Microforming by Extrusion Test

Characteristics and Experimental Study on Extruding-Bulging Process of Aluminum-Alloy Tube with a Low Melting Point Plastic Medium

Simulation Analysis of Rheological Behavior of Plastic Melt in Micro-extrusion

Experiments And Numerical Simulation Of Micro Gears In Micro Injection Molding

Plastic Deformation Size Effects in Micro-Compression of Pure Nickel with A Few Grains Across Diameter