Abstract:In order to investigate the wrinkling behavior of thin-walled tubes under complex stress states, a dedicated experimental setup was designed and manufactured. In this experimental setup, the internal pressure, the external pressure and the axial feeding of left and right punches were coupled together through accurate closed-loop servo control. Thin-walled 5A02 aluminum alloy tubes were pushed into the die cavity under different internal pressures or under the combined actions of internal and external pressures with the same amount of axial feeding. Meanwhile, the wrinkle formation, as well as the stress state, was predicted numerically using the FEA Abaqus/Explicit solver. It has been found that the number and shape of wrinkles are strongly dependent on the internal pressure when only internal pressure is applied to the inner surface of the tube. Furthermore, the wrinkle formation is closely related to the inhomogeneous stress distribution induced by local bending and axial displacement. Moreover, the shape of wrinkles can be fitted effectively using the GaussAmp function when the internal pressures of 1.2ps, 1.6ps and 1.8ps (ps represents the initial yield pressure for the tube) are applied. In addition, the effect of external pressure has been discussed under three cases and it is shown that the wrinkling behavior exhibits hardly any dependence on the external pressure for the constant pressure difference. Finally, the formation of middle wrinkle can be prevented by higher external pressure both for the constant internal pressure and the variable internal pressure.

Characteristics and Experimental Study on Extruding-Bulging Process of Aluminum-Alloy Tube with a Low Melting Point Plastic Medium

Extruding-bulging process of thick-walled tubes with low-melting-point plastic medium

Research on aluminum alloy sheet thermoplastic deformation behavior based upon warm bulging test

Further Assessment of the Plastic Instability of Thin-Walled Tubes in Double-Sided Hydro-Bulging Process with Verification Experiments

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

Numerical simulation and experimental study on axial compression electromagnetic bulging of aluminum alloy tube

The Bulging Behavior of Thick-Walled 6063 Aluminum Alloy Tubes under Double-Sided Pressures

Evaluation of Formability and Material Characteristics of Aluminum Alloy Friction Stir Welded Tube Produced by a Novel Process

Experiments on Electrohydraulic Forming and Electromagnetic Forming of Aluminum Tube

Whole Process Modeling of Joining of Flareless AA 6061-T4 Tube by Extrusion-Bulging Forming Using a Polyurethane Elastomer Medium

Plastic Deformation on Hydroforming of Aluminum Alloy Tube with Rectangular Sections

Superplasticity of Al-Mg aluminum alloys tube

Study on Extrusion of Aluminum Microchannel Flat Tube

Influence of mechanical properties of tube on forming limits and deformation characteristics in expansion drawing process

Experimental investigations on extruded 6063 aluminium alloy tubes under complex tension-compression stress states

Analysis of Bending Deformation and Stress of 6063-T5 Aluminum Alloy Multi-Cavity Tube Filled with Liquid

Microbulging Extrusion of Aluminum Alloy to Fabricate Micro/meso Features for Heat Pipes

Investigation into Wrinkling Behavior of Thin-Walled 5a02 Aluminum Alloy Tubes under Internal and External Pressure

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion

Experimental Study of the Tube Axial Compression Forming Process with Free Dieless Deformation

Deformation Analysis of Double-Sided Tube Hydroforming in Square-Section Die