Abstract:Equal channel angular pressing (ECAP) is a novel method for producing very high plastic strain, and, subsequently, ultrafine grains in materials, with no change in the billet s shape. However it is very important. to understand the deformation behavior of the materials and their relationships with the friction condition and tooling configuration during the ECAP process before it can be exploited in the engineering field. In this study, the plastic deformation behavior of pure Al during the ECAP process with a die corner angle (120...) was investigated using the commercial two-dimensional rigid-plastic finite element software (DEFORM2D). It has been found that the ECAP process was characterized by five steps based on the analysis of the calculated load-ram displacement curve (fast increasing, slowly increasing, another fast increasing, steady state and finally decreasing stages). The inhomogeneous strain distribution within the billets was analyzed by separating the billets into a front transient zone, an end transient zone, an outer less sheared zone, and the remaining shearing deformation zone, which is also proved by the experiment using the billets with scribed grids. Elimination of friction will improve the deformation inhomogeneity of the billet, but cannot eliminate the deformation inhomogeneity. The homogeneity of the strain distribution in the center of the billet is strongly dependent upon the shape of the deformation zone, i.e. angle phi, which will influence the material flow rate distribution and the stress state. Using a corner die instead of a round die, the material flow rate in the main deformation zone is nearly homogenous because of the inexistence of the tensile stress component in the outer part of the billet; consequently the homogeneity of deformation is greatly enhanced.

Analysis of pressure head during the process of equal channel angular pressing:experiment and simulation

Analysis on Force of Pressure Head During ECAP Based on Simulation

3D Finite Element Simulation of Equal Channel Angular Pressing

Tensile and Compressive Deformation Behaviors of Commercially Pure Al Processed by Equal-Channel Angular Pressing with Different Dies

Study on the Extrusion Load During Equal Channel Angular Pressing

Strain Evaluating Method of Equal Channel Angular Pressing

Experimental and Numerical Investigation on Pure Aluminum by ECAP

Finite Element Analysis of Backpressure Effect During Equal Channel Angular Pressing/Extrusion for Ultrafine Grain Metal Preparation

Numerical Simulation of Equal-Channel Angular Pressing of Commercial Pure Aluminum

Influence of Outer Corner Angle (OCA) on the Plastic Deformation and Texture Evolution in Equal Channel Angular Pressing

Analysis of plastic deformation behavior during equal channel angular pressing

Numerical Simulation of Equal Channel Angular Pressing of a Low-Carbon Steel and Analysis of Its Microstructure

Computer Simulation of the Effects of Friction on the Formation of Equal Channel Angular Pressing

Investigation on the geometrical aspect of deformation during equal-channel angular pressing by in-situ physical modeling experiments

Finite Element Analysis for Multi-pass Equal Channel Angular Pressing

A Study on the Aluminum Alloy AA1050 Severely Deformed by Non-Equal Channel Angular Pressing

On the Influence of Mesh Size During Finite Element Simulation of Equal Channel Angular Pressing

New Formulas of Shear Strain During Equal-channel Angular Pressing Process with Consideration of Influences of Velocity and Motion Trajectory

Finite Element Modeling the Effect of Pressing Temperature and Temperature Rise on ECAE Process of CP-Ti

Application Research of Equal-channel Angular Pressing Technology

Effects of processing factors of equal-channel angular pressing on the structure and mechanical properties of Al,Mg and their alloys