Abstract:A Cu-0.41Mg-0.06Ca (wt.%) alloy was processed by equal channel angular pressing (ECAP) for up to 12 passes via Bc route at room temperature, and its homogeneity was evaluated from three aspects of hardness, microstructure and crystallographic texture. The hardness was measured in detail on the whole transverse planes, and the microstructure and the crystallographic texture in the central and bottom regions on the transverse planes were investigated by electron backscatter diffraction (EBSD) technique. After 1 ECAP pass, the hardness in the central region was 9.4% higher than that in the bottom region; the microstructure in the central region consisted of the elongated grains, while that in the bottom region was composed of the slightly distorted grains; the crystallographic texture in the central region followed the ideal orientations of the ECAP crystallographic texture, nevertheless the crystallographic texture in the bottom region obviously deviated from any ideal orientation of the ECAP crystallographic texture. Then, with the increase of ECAP passes, the hardness and microstructure differences between in the two regions gradually weakened, and the deviation of the crystallographic texture in the bottom region gradually decreased. After 8 ECAP passes, the both regions showed the same hardness, the similar ultrafine-grained microstructure and the similar crystallographic texture. The difference formation should be attributed to the non-uniform strain caused by the friction between the sample and the die wall, rather than caused by the corner gap. The difference weakening should be attributed to the strain hardening behavior of metals. The strength calculation showed that the Cu-Mg-Ca alloy after 8 ECAP passes had almost the same yield strengths where 593 MPa for the central region and 583 MPa for the bottom region, showing only 1.7% difference.

Numerical Simulation of Equal Channel Angular Pressing of a Low-Carbon Steel and Analysis of Its Microstructure

Numerical Simulation of Equal-Channel Angular Pressing of Commercial Pure Aluminum

Tensile and Compressive Deformation Behaviors of Commercially Pure Al Processed by Equal-Channel Angular Pressing with Different Dies

Tensile Deformation Behaviors of CuNi Alloy Processed by Equal Channel Angular Pressing

Computer Simulation of the Effects of Friction on the Formation of Equal Channel Angular Pressing

Finite Element Simulation of Equal Channel Angular Pressing of Ti-6Al-4V Alloy

Finite Element Analysis for Multi-pass Equal Channel Angular Pressing

Ebsp Investigation of Microstructure and Texture Evolution During Equal Channel Angular Pressing of Aluminium

Estimation of Friction During Equal Channel Angular (ECA) Pressing of Aluminum Alloys

Direct Observation of Shear Deformation During Equal Channel Angular Pressing of Pure Aluminum

Effect of equal-channel angular pressing on structure of al alloy 2024

Three Dimensional Finite Element Analysis of Ti-6Al-4V Alloy During Equal Channel Angular Pressing

Anisotropic Compressive Properties of Iron Subjected to Single-Pass Equal-Channel Angular Pressing

Thermal Stability of Ultrafine-Grained Low Carbon Steel Processed by Equal-Channel Angular Pressing

Three-Dimensional Microstructures and Tensile Properties of Pure Iron During Equal Channel Angular Pressing

Investigation on the geometrical aspect of deformation during equal-channel angular pressing by in-situ physical modeling experiments

Observation of macroscopic shear band in aluminum-based alloy during equal-channel angular pressing

Study on equal channel angular pressing process of Mg–Zn–Y–Mn–Ti magnesium alloy enhanced by lamellar LPSO phase and spherical W phase

Microstructure Evolution and Mechanical Properties of Fcc Metallic Materials Subjected to Equal Channel Angular Pressing

Numerical Simulation of Semi-Solid Billet Preparation by Equal Channel Angular Extrusion

Three-dimensional numerical analysis and experimental investigation of grain refinement in multi-pass equal channel angular pressing for round-workpieces