Abstract:In the present study, the mechanical properties of Fe processed via severe plastic deformation (equal-channel angular pressing (ECAP)) at room temperature were investigated for the first time. The grain size of annealed Fe, with an initial grain size of about 200 µm, was reduced drastically during ECAP. After eight passes, the grain size reaches 200 to 400 nm, as documented by means of transmission electron microscopy (TEM). The value of microhardness during pressing increases 3 times over that of the starting material after the first pass and increases slightly during subsequent pressing for higher-purity Fe. Examination of the value of microhardness after eight passes as a function of post-ECAP annealing temperature shows a transition from recovery to recrystallization, an observation that resembles the behavior reported for heavily deformed metals and alloys. The tensile and compression behaviors were examined. In tension, a drop in the engineering stress-engineering strain curve beyond maximum load was observed both in the annealed Fe and the ECAP Fe. This drop is related to the neck deformation. The fracture surface, examined by scanning electron microscopy (SEM), shows vein patterns, which is different from the dimples found on the fracture surface of annealed Fe. In compression, an initial strain-hardening region followed by a no-strain-hardening region was observed in the ECAP Fe. The yield strength in tension of the ECAP Fe was observed to be higher than that in compression. The strengthening mechanisms and softening behavior are discussed.

Anisotropic Compressive Properties of Iron Subjected to Single-Pass Equal-Channel Angular Pressing

Tensile and Compressive Deformation Behaviors of Commercially Pure Al Processed by Equal-Channel Angular Pressing with Different Dies

Tensile Deformation Behaviors of CuNi Alloy Processed by Equal Channel Angular Pressing

Three-Dimensional Microstructures and Tensile Properties of Pure Iron During Equal Channel Angular Pressing

Mechanical properties of iron processed by severe plastic deformation

Compressive Behavior of Engineered Cementitious Composites under High Strain-Rate Loading

Ebsp Investigation of Microstructure and Texture Evolution During Equal Channel Angular Pressing of Aluminium

Microstructure and mechanical properties after annealing of equal-channel angular pressed interstitial-free steel

Impact of Equal Channel Angular Pressing on Mechanical Behavior and Corrosion Resistance of Hot-Rolled Ti-2Fe-0.1B Alloy

Study on equal channel angular pressing process of Mg–Zn–Y–Mn–Ti magnesium alloy enhanced by lamellar LPSO phase and spherical W phase

Grain Refinement and Strengthening of an Aluminum Alloy Subjected to Severe Plastic Deformation through Equal-Channel Angular Pressing

Simulation And Experimental Investigation For The Homogeneity Of Ti49.2ni50.8 Alloy Processed By Equal Channel Angular Pressing

Corrosion Behavior of Commercial Aluminum Alloy Processed by Equal Channel Angular Pressing

New Formulas of Shear Strain During Equal-channel Angular Pressing Process with Consideration of Influences of Velocity and Motion Trajectory

Fracture Toughness Anisotropy of Ultrafine-Grained Pure Copper Processed by Equal Channel Angular Pressing

Experimental and Numerical Investigation of the ECAP Processed Copper: Microstructural Evolution, Crystallographic Texture and Hardness Homogeneity

An Investigation on Rolling Texture Transition in Copper Preprocessed by Equal Channel Angular Pressing

3D FEM Simulation of Multipass ECAP Ti-50.8%Ni at Various Temperatures

Effect of Single-Pass Rolling on Microstructure and Mechanical Properties of AZ31 Alloy Processed by Equal Channel Angular Pressing

Annealing behaviour and mechanical properties of severely deformed interstitial free steel

Effect of Sample Size on Microstructure and Mechanical Properties of OFHC Copper Processed by Equal Channel Angular Pressing