Abstract:In the present study, the mechanical properties of Fe processed via severe plastic deformation (equal-channel angular pressing (ECAP)) at room temperature were investigated for the first time. The grain size of annealed Fe, with an initial grain size of about 200 µm, was reduced drastically during ECAP. After eight passes, the grain size reaches 200 to 400 nm, as documented by means of transmission electron microscopy (TEM). The value of microhardness during pressing increases 3 times over that of the starting material after the first pass and increases slightly during subsequent pressing for higher-purity Fe. Examination of the value of microhardness after eight passes as a function of post-ECAP annealing temperature shows a transition from recovery to recrystallization, an observation that resembles the behavior reported for heavily deformed metals and alloys. The tensile and compression behaviors were examined. In tension, a drop in the engineering stress-engineering strain curve beyond maximum load was observed both in the annealed Fe and the ECAP Fe. This drop is related to the neck deformation. The fracture surface, examined by scanning electron microscopy (SEM), shows vein patterns, which is different from the dimples found on the fracture surface of annealed Fe. In compression, an initial strain-hardening region followed by a no-strain-hardening region was observed in the ECAP Fe. The yield strength in tension of the ECAP Fe was observed to be higher than that in compression. The strengthening mechanisms and softening behavior are discussed.

Three-Dimensional Microstructures and Tensile Properties of Pure Iron During Equal Channel Angular Pressing

Tensile and Compressive Deformation Behaviors of Commercially Pure Al Processed by Equal-Channel Angular Pressing with Different Dies

Tensile Deformation Behaviors of CuNi Alloy Processed by Equal Channel Angular Pressing

Anisotropic Compressive Properties of Iron Subjected to Single-Pass Equal-Channel Angular Pressing

Microstructure and mechanical properties of ultrafine grained IF steel processed by equal channel angular pressing

Microstructures and Mechanical Properties of Commercial Purity Iron Processed by Asymmetric Rolling

Mechanical properties of iron processed by severe plastic deformation

Effect of Route on Tensile Anisotropy in Equal Channel Angular Pressing

Microstructure and mechanical properties after annealing of equal-channel angular pressed interstitial-free steel

Microstructural evolution and mechanical properties of AZ31 Mg alloy fabricated by a novel bifurcation-equal channel angular pressing

Ebsp Investigation of Microstructure and Texture Evolution During Equal Channel Angular Pressing of Aluminium

Numerical Simulation of Equal Channel Angular Pressing of a Low-Carbon Steel and Analysis of Its Microstructure

Grain-refining and Strengthening Mechanisms of Bulk Ultrafine Grained CP-Ti Processed by L-ECAP and MDF

Microstructure and Mechanical Properties of Mg96Y3Zn1 Alloy Processed by Equal Channel Angular Pressing

Microstructure and Properties of Ultrafine-Grained Aluminum-Based Alloy Processed by Equal Channel Angular Pressing

Microstructure Evolution and Mechanical Properties of a Ti–35Nb–3Zr–2Ta Biomedical Alloy Processed by Equal Channel Angular Pressing (ECAP)

Thermal Stability of Ultrafine-Grained Low Carbon Steel Processed by Equal-Channel Angular Pressing

Microstructure and mechanical properties of AlMgSi alloys after equal channel angular pressing at room temperature

Microstructural Evolution and Micro/Meso-Deformation Behavior in Pure Copper Processed by Equal-Channel Angular Pressing

Impact of Equal Channel Angular Pressing on Mechanical Behavior and Corrosion Resistance of Hot-Rolled Ti-2Fe-0.1B Alloy

Effect of original microstructure on microstructure and properties of pure copper subjected to equal channel angular pressing(ECAP)