Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. After pneumatic shot peening, compressive residual stress is induced on the surface of the target, which will improve the fatigue life. During the process, surface roughness is also induced, which may reduce the fatigue life. To achieve the optimum compressive residual stress with the smallest surface roughness, the formation mechanism of the residual stress field and the surface topography are revealed. Then, pneumatic shot peening is simulated by using a discrete element method–finite element method coupled model. Based on the effects of four variables (the incident angle θ, the initial shot velocity v0, the shot radius R) and the mass flow rate rm on five parameters (the equivalent plastic strain, the equivalent stress, the surface compressive residual stress, the maximum compressive residual stress), the surface roughness is investigated. The results show that it induces a residual elastic–plastic strain after the impact of a single shot, which can form a crater and a hemispherical residual stress field. After the impact of many random shots, scattered craters connect with each other, therewith a rough and continuous surface topography is formed. Scattered residual stress fields couple with each other, and a constant residual stress layer with the compressive residual stress in the surface and the tensile residual stress in the subsurface are formed. All five parameters are determined by the residual elastic–plastic strain, which increases as the augment of the normal impact velocity, the shot mass, and the coverage rate. Along with the increase of θ and rm, these five parameters firstly increase and then decrease; with the increase of v0 and R, these five parameters increase. Therefore, reasonable values of θ, v0, R, and rm should be chosen to obtain the optimum compressive residual stress with as small surface roughness as possible.

The numerical simulation of shot peening process with an equivalent static loading method

Shot Stream Finite Element Model for Shot Peening Numerical Simulation and Its Experiment Study

Investigation on Experiments and Numerical Modelling of the Residual Stress Distribution in Deformed Surface Layer of Ti–6Al–4V after Shot Peening

Value of Penalty Factor During Simulation Stress Wave

A simulation modeling methodology considering random multiple shots for shot peening process

Numerical simulation on influencing factors of micropartical shot peening

Numerical Simulation of Residual Stress Field Induced by Ultrasonic Shot Peening

Numerical modeling of ultrasonic shot peening with an accurate impact velocity

Simulations of the effect of shot peening backstress on nanoindentation

Analysis of Residual Stresses and Three Dimensional Stress Intensity Factors for Shot Peened Single-edge-notch-tension Specimens

An Analytical Model for Shot-Peening Induced Residual Stresses

Finite Element Analysis for Shot-Peening Models of Single Shot Impact and Multiple Impingement

Elastic Contact Analysis of Shot-Peened Rough Surfaces

Studies on residual stress and surface topography after pneumatic shot peening using discrete element method–finite element method coupled model

Numerical Simulation on Failure Process of Prestressed Concrete Structures under Impact Load

Literature review of numerical simulation and optimisation of the shot peening process

Calculation of Relaxation of Residual Stress and Change of Yield Strength in Shot Peened Layer

Finite Element Simulation of Residual Stress of 18Crnimo7-6 Gear Steel after Shot Peening

Investigation of the effects of shot overlap and rigid body assumptions on surface layer characteristics in shot peening simulation

ABAQUS Simulation of Residual Stress Induced by Waterjet Peening

Measurement and Identified Prediction Equation for Residual Stress Distribution in Aluminum Alloy A5052 under Various Pneumatic Shot Peening Conditions