Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. After pneumatic shot peening, compressive residual stress is induced on the surface of the target, which will improve the fatigue life. During the process, surface roughness is also induced, which may reduce the fatigue life. To achieve the optimum compressive residual stress with the smallest surface roughness, the formation mechanism of the residual stress field and the surface topography are revealed. Then, pneumatic shot peening is simulated by using a discrete element method–finite element method coupled model. Based on the effects of four variables (the incident angle θ, the initial shot velocity v0, the shot radius R) and the mass flow rate rm on five parameters (the equivalent plastic strain, the equivalent stress, the surface compressive residual stress, the maximum compressive residual stress), the surface roughness is investigated. The results show that it induces a residual elastic–plastic strain after the impact of a single shot, which can form a crater and a hemispherical residual stress field. After the impact of many random shots, scattered craters connect with each other, therewith a rough and continuous surface topography is formed. Scattered residual stress fields couple with each other, and a constant residual stress layer with the compressive residual stress in the surface and the tensile residual stress in the subsurface are formed. All five parameters are determined by the residual elastic–plastic strain, which increases as the augment of the normal impact velocity, the shot mass, and the coverage rate. Along with the increase of θ and rm, these five parameters firstly increase and then decrease; with the increase of v0 and R, these five parameters increase. Therefore, reasonable values of θ, v0, R, and rm should be chosen to obtain the optimum compressive residual stress with as small surface roughness as possible.

Numerical simulation on influencing factors of micropartical shot peening

Numerical simulation of influence factors of stress distribution of weld-bonded joint under peeling load

Numerical modeling of ultrasonic shot peening with an accurate impact velocity

Studies on residual stress and surface topography after pneumatic shot peening using discrete element method–finite element method coupled model

A simulation modeling methodology considering random multiple shots for shot peening process

Shot Stream Finite Element Model for Shot Peening Numerical Simulation and Its Experiment Study

Numerical Simulation of Residual Stress Field Induced by Ultrasonic Shot Peening

Investigation of the effects of shot overlap and rigid body assumptions on surface layer characteristics in shot peening simulation

The numerical simulation of shot peening process with an equivalent static loading method

Numerical and experimental studies on needle impact characteristics in ultrasonic shot peening

A theoretical model for predicting the surface topography of inhomogeneous materials after shot peening

Multiphysics Modelling of Warm Shot Peening of AISI 4140 Steel

Simulations of the effect of shot peening backstress on nanoindentation

An experimental and numerical coupled method to predict grain refinement and mechanical properties of gradient microstructure material by shot peening

Molecular modeling of Ti-6Al-4V alloy shot peening: the effects of diameter and velocity of shot particles and force field on mechanical properties and residual stress

Literature review of numerical simulation and optimisation of the shot peening process

An analytical model for predicting residual stress in shot peening with strain energy method

A new analytical model to predict residual stress induced by ultrasonic shot peening

Optimization of Parameters for the Best Shot Peening Effect based on Surface Response and Neural Network Model

A study of the effect of dual shot peening on the surface integrity of carburized steel: combined experiments with dislocation density-based simulations

Analysis of residual stress of gear tooth root after shot peening process