Abstract:High residual tensile stress is an important factor contributing to stress corrosion cracking (SCC). Shot peening can impose compressive stresses on the surface of welded joints that negate the tensile stresses to enhance the SCC resistance of welded joints. In the present work, the distribution of residual stress caused by welding is measured by X-ray diffraction method. The maximum stress in the weld is close to the yield strength of AISI 304 stainless steel, and the stresses are negative at both ends of the weld and far from the weld. The X-ray method is also used to measure stress caused by shot-peening. The results show that the higher the peening coverage, the higher the residual compressive stresses in the surface of weldments. While under the same condition, the residual compressive stresses induced by glass beads shot-peening are larger than those by cast steel shots. Temperature and stress fields of welding are simulated by using ABAQUS codes. The 3-D solid elements are used in FEM. Temperature depending on material properties as well as the convection and radiation as boundary conditions are considered. The 3-D linear reduced-integration elements are used to simulate the shot peening process. The results of simulation have a good agreement with experimental data. All unpeened and peened weldments are immersed in boiling 42% magnesium chloride solution during SCC test. Unpeened specimens crack after immersion for 6 hours. The steel-peened specimens with 50% coverage crack after 3 10 hours, while the steel-peened specimens with 100% coverage crack for 3500 hours. However, steel-peened specimens with 200% coverage and glass-peened specimens with 50%, 100% and 200% coverage are tested for a total of 3500 hours without visible stress corrosion cracks in the peened surfaces. The experiment results indicate that shot peening is an effective method for protecting weldments against SCC and weldments peened by glass beads resist SCC better than those peened by steel shots.

Numerical Simulation of Residual Stress Field Induced by Ultrasonic Shot Peening

An experimental study of residual stress induced by ultrasonic shot peening

A new analytical model to predict residual stress induced by ultrasonic shot peening

Numerical modeling of ultrasonic shot peening with an accurate impact velocity

Finite Element Simulation of Residual Stress Field Induced by Ultrasonic Impact Treatment

Surface Nanocrystallization and Numerical Modeling of 316L Stainless Steel during Ultrasonic Shot Peening Process

Influence of Laser Peening Parameters on Residual Stress Field of 304 Stainless Steel

FE analysis of shot-peening-induced residual stresses of AISI 304 stainless steel by considering mesh density and friction coefficient

Investigation Of The Influence Of Shot Peening On Stress Corrosion Cracking Of Stainless Steel Welded Joints

Influence of laser parameters on residual stress field of AISI 304 stainless steel induced by laser peening: A finite element analysis

A comprehensive analysis of the impact zone of compressive residual stress induced by ultrasonic shot peening

Residual Stress Field Induced by Laser Peening: a Finite Element Analysis

ABAQUS Simulation of Residual Stress Induced by Waterjet Peening

Effect of Ultrasonic Shot Peening on Stress Corrosion of 304 Austenitic Stainless Steel

Ultrasonic shot peening of 316L stainless steel – Experimental and analytical approach

An analytical model for predicting residual stress in shot peening with strain energy method

Investigation on experiments and numerical modeling of the residual stress distribution in deformed surface layer of Al6061 alloy after ultrasonic peening treatment

Modification of Residual Stresses in Laser Additive Manufactured AlSi10Mg Specimens Using an Ultrasonic Peening Technique

Shot Stream Finite Element Model for Shot Peening Numerical Simulation and Its Experiment Study

Numerical simulation on influencing factors of micropartical shot peening

A simulation modeling methodology considering random multiple shots for shot peening process