Abstract:Summary form only given. Atmospheric pressure glow discharges (APGD) generated at radio frequencies generally employ naked electrodes, since the rapid oscillation of the applied voltage suppress very effectively a sustained energy supply to an unrestricted current growth. Consequently, RF APGD are typically stable and it is usually unnecessary to insulate electrodes with dielectric barriers - a common and often essential technique for low frequency APGD in the kilohertz range. As more and more material processing procedures favor high-density plasmas for a superior application efficiency, it is highly desirable that RF APGD can be operated at increasingly high current densities thus imposing greater demands on reliable control of plasma stability. Inevitably, the rapid oscillation of RF voltages alone becomes no longer adequate to ensure plasma stability, and new and additional stability control strategies become important. In this contribution, we present a computational study of how electrode insulation may be used to enhance plasma stability in RF APGD. Temporal characteristics of the discharge current, the applied voltage and the gas voltage are computed over a full range of the current density, from pre-breakdown to arcing. Relationships of the current density with both the applied and the gas voltages are studied in details. These are used to demonstrate that RF atmospheric dielectric-barrier discharges (DBD) acquire a negative differential conductivity at high current densities and as such acquire a similar level of plasma stability to that in conventional RF APGD. However with the dielectric barriers, the differential conductivity of the plasma enclosing electrode unit is always positive in the external circuit. As a result, any plasma instability is suppressed easily and conveniently by capping the power output of the RF power source. In other words, RF atmospheric DBD are more stable than conventional RF APGD even though their plasma characteristics are v- ry similar. Results reported here are likely to form a basis of a stability control strategy for RF APGD

The effect of air plasma on barrier dielectric surface in dielectric barrier discharge

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Effect of Atmospheric Pressure Dielectric Barrier Discharge Air Plasma on Electrode Surface

Transition from Glow-Like to Streamer-Like Discharge in Atmospheric Pressure Dielectric Barrier Discharge Controlled by Variable Dielectric Surface Layer Permittivity

Plasma Distribution Characteristics of 37-kHz AC Dielectric Barrier Discharge in Atmospheric Air

Study on Influential Factors of Dielectric Barrier Discharge in Air

Study on the Influence of Dielectric Barrier Materials on the Characteristics of Atmospheric Plasma Jet in Ar

Effect Of Surface Charge Trapping On Dielectric Barrier Discharge

Mechanical Characteristics of Dielectric Barrier Discharge Plasma

Investigation of Surface Charge Distribution and Its Influence on Characteristics of Dielectric Barrier Discharge

Experimental Research on Microdischarge Characteristics of DBD

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Effect of Dielectric Barrier Discharge on Semiconductor Si Electrode Surface

Effect of dielectric barriers in RF atmospheric pressure glow discharges

Investigation of Dielectric Barrier Discharge in Air for Materials Surface Modification by Optical Emission Spectrometry

Surface Modification of Insulating Polymers by Using APGD and DBD in Air

Effects of Dielectric Barriers in Radio-Frequency Atmospheric Glow Discharges

Study of Characteristics of Coplanar Dielectric Barrier Discharge

Study of Homogeneous DBD with Fine Wire Meshes and PET Films in Air at Atmospheric Pressure

The Time Evolution of Electrical and Thermodynamic Characteristics of Surface Dielectric Barrier Discharge Caused by Dielectric Degradation