Abstract:Dielectric barrier discharge (DBD) is proved to be an effective method for surface treatment of polymers over the past 20 years and is now widely used in the fields of surface modification. In this paper, surface treatment of polyethylene terephthalate (PET) films for improving the hydrophilicity using DBD excited by unipolar nanosecond pulses is presented. Two typical discharges exhibiting homogeneous and filamentary modes are obtained under certain experimental conditions, and then, they are used to modify the surface of PET films. The microstructure and properties of the film surface before and after treatment are characterized with water contact angle measurement, scanning electron microscope, atomic force microscope, and X-ray photoelectron spectroscope. The results show that, with the treatment power density of 192 and 158 mW/cm(2) in filamentary and homogeneous modes, respectively, surface morphology and property after treatment are significantly changed, and the physical etching and introduction of oxygen-containing polar functional groups account for the decease of surface contact angle and the increase of surface roughness. Compared with the filamentary DBD treatment, the homogeneous DBD (HDBD) is more effective in surface treatment, such as lower contact angle, higher roughness, and more oxygen-containing function groups after treatment. It is attributed to the fact that the HDBD can achieve a uniform treatment and can make the physical and chemical interaction much sufficient.

Polypropylene Surface Modification Model in Atmospheric Pressure Dielectric Barrier Discharge

Study of Polypropylene Surface Modified by Dielectric Barrier Discharge

Improved Surface Modification of Polymer Films by Energy-Compressed Dielectric Barrier Discharge with Discharge-Time-Regulated Power Source

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

Effect of Magnetic Confinement Barrier Discharge on Surface Properties of PP

Surface Treatment of Polypropylene Films Using Dielectric Barrier Discharge with Magnetic Field

Study on Polypropylene Modified by Water Electrode Air Plasma

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Surface Treatment of PET and PP by Atmospheric Pressure Dielectric Barrier Discharge for Improvement in Hydrophilicity

Surface Potential Decay on LDPE and Its Nanocomposites

Study on Polypropylene Powder Degradation in Dielectric Barrier Discharge

Experimental Study of Accelerating Surface Charge Dissipation on Polymer Treated by Repetitively Pulsed Discharge Plasmas

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Surface Treatment of Polyethylene Terephthalate Films Using Dbd Excited by Repetitive Unipolar Nanosecond Pulses in Air at Atmospheric Pressure

Study on Polystyrene Surface Modification in Dielectric Barrier Discharge

Neural Networks Model of Polypropylene Surface Modification by Air Plasma

PAA Polymerized Downstream of a High Pressure DBD Plasma

The effect of air plasma on barrier dielectric surface in dielectric barrier discharge

Modification of terylene fabric by homogeneous discharge in air at atmospheric pressure

Surface modification of polyester film by glow discharge tunnel at atmospheric pressure

The influences of solid surface modification on the crystallizability of polypropylene