Abstract:This paper investigates mechanisms of the surface charge dissipation of silicone rubber (SiR) after dielectric barrier discharge (DBD) plasma treatments in an open air. Electrical and physicochemical properties of the untreated and plasma treated samples were evaluated by surface and volume conductivity, surface potential decay (SPD) measurements, Fourier transform infrared (FT-IR), and water contact angle tests. Results show that the surface conductivity of the plasma treated samples evidently increases with the treatment time. The samples with a longer DBD plasma treatment time enhance the SPD rate after the positive and negative corona charging. However, an abnormal surface potential variation is observed at the beginning of the SPD after the negative corona charging. It is found that the top-bottom surface plasma treatment can further accelerate the SPD of the samples compared with the untreated and single surface plasma treated samples. The physicochemical analysis shows that the concentration of polar groups is increased after the plasma treatment, and the water contact angle is consistently declined with the increase of the plasma treatment time. The calculated trap distribution illustrates that the hole trap energy and the electron trap density of the sample are decreased after the plasma treatments. This investigation attributes the measured SPD of the untreated sample and single surface treated samples to the electrical conduction along the sample surface, but the SPD of the top-bottom surfaces plasma treated samples is enhanced by the charge neutralization and transportation through the material bulk as well as the sample top surface conduction.

Experimental Study of Accelerating Surface Charge Dissipation on Polymer Treated by Repetitively Pulsed Discharge Plasmas

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Bulk Polymerization of Acrylic Acid Using Dielectric-Barrier Discharge Plasma in a Mesoporous Material.

Improved Surface Modification of Polymer Films by Energy-Compressed Dielectric Barrier Discharge with Discharge-Time-Regulated Power Source

Repetitive Nanosecond-Pulse Dielectric Barrier Discharge and Its Application on Surface Modification of Polymers

Surface electric charge decay behavior of Polypropylene (PP) films treated by atmospheric air dielectric barrier discharge

Large-Area Surface Modification of Polymers Using A Cold Pulsed Glow Discharge

Surface Treatment of PET and PP by Atmospheric Pressure Dielectric Barrier Discharge for Improvement in Hydrophilicity

Surface Modification of Polyimide Films Using Unipolar Nanosecond-Pulse DBD in Atmospheric Air

Hydrophilic Improvement of Polymers Treated by Homogeneous Nanosecond Pulse Dielectric Barrier Discharge in Atmospheric Air

Improvement of Polytetrafluoroethylene Surface Energy by Repetitive Pulse Non-Thermal Plasma Treatment in Atmospheric Air

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

Surface Treatment of Polyethylene Terephthalate Films Using Dbd Excited by Repetitive Unipolar Nanosecond Pulses in Air at Atmospheric Pressure

Surface Modification of Polyethylene (pe) Films Using Dielectric Barrier Discharge Plasma at Atmospheric Pressure

Surface Modification of PE Film by DBD Plasma in Air

Surface Potential Decay and DC Surface Flashover Characteristics of DBD Plasma-Treated Silicone Rubber

10 Ns Pulsed Atmospheric Air Plasma for Uniform Treatment of Polymeric Surfaces

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Atmospheric Air Homogenous DBD Plasma Excited by Bipolar Nanosecond Pulse Used for Improving the Hydrophilic Property of Polypropylene

Surface Treatment of Polypropylene Films Using Dielectric Barrier Discharge with Magnetic Field

Effects of Air Dielectric Barrier Discharge Plasma Treatment Time on Surface Properties of Pbo Fiber