Abstract:Summary form only given. The dielectric barrier discharge (DBD) in air at atmospheric pressure was investigated with electrical measurement and fast photography. Homogeneous DBD without filaments was obtained in a gap of a length as long as 3 mm, which has never been reported in previous literatures. The air gap was in between two plane-parallel electrodes of 50 mm in diameter, each covered by a specific ceramic plate with a thickness of 1.5∼3.25 mm. By subtracting the displacement current from the total current, there appears one current peak per half cycle of the applied sinusoidal voltage, which is typical for homogeneous DBD. The current peak is 1 mA in amplitude and about 85 µs in FWHM (full width at half magnitude). Side-view photographs with 10 ns exposure time taken at the time about the peak of the current pulse showed that there were no filaments in the discharge gap. A luminous layer close to the instantaneous anode was observed, indicating the homogeneous DBD was a Townsend discharge. When choosing a ceramic thinner than 1.5 mm, some filaments randomly appeared in the gap, as was called a mixed mode of homogenous and filamentary DBD. This was because in DBD the dielectric capacitance played an important role in the limitation of the discharge current. A smaller capacitance would help to avoid an electron avalanche overdeveloping to a streamer. When a stable Townsend discharge was maintained, the breakdown voltage was determined to be only 8.3 kV, much lower than the static breakdown voltage of 11.2 kV for the same air gap of 3 mm in length. The formation of Townsend discharge was attributed to the uniqueness of the shallow traps on the surface of the specific ceramic plate and the common effect of the current limitation by dielectric.

Effect Of Surface Charge Trapping On Dielectric Barrier Discharge

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

The effect of air plasma on barrier dielectric surface in dielectric barrier discharge

Characteristics of Shallow Traps in the Dielectric Surface and Their Effects on Diffuse Dielectric Barrier Discharge in Air

Effect of Dielectric Barrier Discharge on Semiconductor Si Electrode Surface

Distribution Characteristics of Surface Charge of Dielectric Barrier Columnar Discharge in Atmospheric Helium

Influence of Wire Mesh Electrodes on Dielectric Barrier Discharge

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Homogeneous Dielectric Barrier Discharges in Atmospheric Air and Its Influencing Factor

Mechanical Characteristics of Dielectric Barrier Discharge Plasma

Influence of Dielectric and Electrode on DBD at Atmospheric Pressure

Local Discharge and Distribution of Wall Charge in Coplanar Dielectric Barrier Discharge

The control mechanism of surface traps on surface charge behavior in alumina-filled epoxy composites

Realization of meter-scale and high-density of charged particles by surface dielectric barrier discharge

Study of Dielectric Barrier Townsend Discharge in Air at Atmospheric Pressure

Effect of nitrogen/oxygen ratios on surface charge distributions generated by repetitive surface dielectric barrier discharges

Experimental study of homogeneous dielectric barrier discharge in air at atmospheric pressure

Experimental Research on Microdischarge Characteristics of DBD

Effect of insulation distance on surface charge accumulation at the gas-solid interface under DC voltage

Simultaneous measurement of electrical potential on both sides of the dielectric surface in a parallel-plate dielectric barrier discharges and analysis of net electric field