Abstract:It is believed that the maximum spacing for generating a uniform non-equilibrium plasma in atmospheric pressure air is 4 mm. In this paper, we propose a new type of DBD discharge structure to address this challenge. The left end of the structure rapidly increases the discharge spacing from 0.5 mm to 6 mm, while the right side of the main discharge gap maintains a uniform spacing of 6 mm. Nanosecond pulse voltage is used to drive the plasma, an ICCD camera is used to capture the image of the plasma during a discharge pulse cycle, which indicates that a uniform plasma within the 6mm spacing of the main discharge gap is generated. Upon further reducing the ICCD camera's exposure time to 20 ns, it is revealed that the uniform plasma is formed due to the rapid propagation of the plasma from left to right at a speed of order of 105 m/s. Due to the small transverse component of the external electric field, this rapid propagation behavior cannot be due to the external electric field. Therefore, this paper further proposes the hypothesis of electric dipole formation leading to this fast propagation. The hypothesis suggests that the charge separation on the surface of the anode forms an electric dipole, which generates a local discharge at its right end. This local discharge further triggers the discharge in the main gap, and the main gap discharge, in turn, forms a dipole due to charge separation again, by repeating this cycle, the plasma propagates rapidly to the right. Further analysis demonstrates that this dipole can indeed produce a strong electric field of up to 41 kV/cm at its right end, which is sufficient to induce a local discharge. Moreover, under such a strong electric field, the electron migration rate can indeed reach 105 m/s.

Simultaneous measurement of electrical potential on both sides of the dielectric surface in a parallel-plate dielectric barrier discharges and analysis of net electric field

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Experimental Research on Microdischarge Characteristics of DBD

Study of Characteristics of Coplanar Dielectric Barrier Discharge

Effect of nitrogen/oxygen ratios on surface charge distributions generated by repetitive surface dielectric barrier discharges

Dielectric Barrier Discharge and Its Applications

Measurement of the Surface Charging of a Plasma Actuator Using Surface DBD

Nanosecond-pulse dielectric barrier discharge using magnetic compression solid-state pulsed power

Characteristics of Nanosecond-pulse Dielectric Barrier Discharge in Atmospheric Air

Electric Field Measurement in Dielectric Barrier Discharges Using Electric Field Induced Second Harmonic Generation in Ambient Air

Similarity Study of Micro-Gap Dielectric Barrier Discharge by Numerical Simulation

Atmospheric pressure uniform dielectric barrier discharge (DBD) in a wide air gap initiated from a narrow starting point

DC-Augmented Dielectric Barrier Discharge (DCA-DBD)

Monitoring of a dielectric barrier discharge-based process using the gas gap voltage

Excitation of Atmospheric Pressure Uniform Dielectric Barrier Discharge Using Repetitive Unipolar Nanosecond-Pulse Generator

Electric field components within a micro-scaled DBD measured by Stark shifting and splitting of helium lines

A Comparative Study of Water Electrodes Versus Metal Electrodes for Excitation of Nanosecond-Pulse Homogeneous Dielectric Barrier Discharge in Open Air

Realization of meter-scale and high-density of charged particles by surface dielectric barrier discharge

Influence of Dielectric and Electrode on DBD at Atmospheric Pressure

Electrical characterization and imaging of discharge morphology in a small-scale packed bed dielectric barrier discharge

Comparison of Experiment and Simulation on Dielectric Barrier Discharge Driven by 50hz AC Power in Atmospheric Air