Abstract:This paper investigates mechanisms of the surface charge dissipation of silicone rubber (SiR) after dielectric barrier discharge (DBD) plasma treatments in an open air. Electrical and physicochemical properties of the untreated and plasma treated samples were evaluated by surface and volume conductivity, surface potential decay (SPD) measurements, Fourier transform infrared (FT-IR), and water contact angle tests. Results show that the surface conductivity of the plasma treated samples evidently increases with the treatment time. The samples with a longer DBD plasma treatment time enhance the SPD rate after the positive and negative corona charging. However, an abnormal surface potential variation is observed at the beginning of the SPD after the negative corona charging. It is found that the top-bottom surface plasma treatment can further accelerate the SPD of the samples compared with the untreated and single surface plasma treated samples. The physicochemical analysis shows that the concentration of polar groups is increased after the plasma treatment, and the water contact angle is consistently declined with the increase of the plasma treatment time. The calculated trap distribution illustrates that the hole trap energy and the electron trap density of the sample are decreased after the plasma treatments. This investigation attributes the measured SPD of the untreated sample and single surface treated samples to the electrical conduction along the sample surface, but the SPD of the top-bottom surfaces plasma treated samples is enhanced by the charge neutralization and transportation through the material bulk as well as the sample top surface conduction.

Effect of Atmospheric Pressure Dielectric Barrier Discharge Air Plasma on Electrode Surface

The effect of air plasma on barrier dielectric surface in dielectric barrier discharge

Effect of Dielectric Barrier Discharge on Semiconductor Si Electrode Surface

Comparing Medium Pressure Dielectric Barrier Discharge (DBD) Plasmas and Classic Methods of Surface Cleaning/activation of Pure Mg for Biomedical Applications

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Influence of DBD Treated Nano‐al2o3 on Thermal and Electrical Insulation Properties of Epoxy Nanocomposites at High Temperatures

Surface charge dissipation and DC flashover characteristic of DBD plasma treated epoxy resin/AlN nanocomposites

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Study on Polystyrene Surface Modification in Dielectric Barrier Discharge

Study the effect of electrode material, its surface, and dielectric material on plasma and properties of plasma-activated water

Surface Modifications of PCB-Based Plasma Sources Induced by Atmospheric Plasma: A Comparative Study of Dielectric and Electrode Materials

Surface Potential Decay and DC Surface Flashover Characteristics of DBD Plasma-Treated Silicone Rubber

Mechanical Characteristics of Dielectric Barrier Discharge Plasma

Air-plasma surface modification of epoxy resin substrate to improve electroless copper plating of printed circuit board

Influence of Dielectric and Electrode on DBD at Atmospheric Pressure

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

Realization of meter-scale and high-density of charged particles by surface dielectric barrier discharge

Surface Treatment of PET and PP by Atmospheric Pressure Dielectric Barrier Discharge for Improvement in Hydrophilicity

Study of Dielectric Barrier Townsend Discharge in Air at Atmospheric Pressure

The effect of bending angle on a flexible electrode DBD plasma under sinusoidal excitation