Abstract:Enhancement-mode (E-mode) GaN MOS-HEMTs using recess process typically face the challenge of precise thickness control, surface roughness issue, and interface traps, all of which could lead to the degradation of the device performance and cause reliability issues. In this article, we use a combined process of atomic layer etching (ALE) technique and atomic layer deposited (ALD) HfSiO dielectric. ALE is repeated oxidation and dry etching process with minimal surface damage, leading to a precisely controlled low-damage recess channel area. The fabricated AlGaN/GaN MOS-HEMTs exhibit E-mode operation with a positive threshold voltage (V-th) of +2.1 V with small V-th dispersion for different devices, an ultrahigh drain current ON-OFF ratio over 1010 and a low ON-resistance (R-ON) of 11.5 Omega . mm at gate-to-drain length (L-GD) of 25 mu m. Source field plate (SFP) structure is employed to reduce the charge trapping process and improve the reliability at high voltages. The current collapse of the E-mode device with SFP structure can be effectively suppressed due to the optimized redistribution of the peak electric field in the gate-to-drain access region, where a significantly improved dynamic R-ON of only 1.17 times increase from the static R-ON after OFF-state V-DS stress of 600 V. Moreover, the enhanced vertical electric field with decreased AlGaN barrier thickness and the positive shift in threshold voltage for the E-mode device can effectively suppress the current collapse, which outperforms the depletion-mode counterpart. The breakdown voltage reaches a considerable value of 1560 V at an OFF-state current density of 1 mu A/mm.

Current Collapse, Memory Effect Free GaN HEMT

Electro-thermal-stress interaction of GaN HEMT breakdown induced by high power microwave pulses

An insight to current collapse in GaN HEMT and suppressing techniques

Evidence of Mobile Holes on GaN HFET Barrier Layer Surface - Root Cause of High Power Transistoramplifier Current Collapse

Current collapse suppression in AlGaInN/GaN HEMTs with thin unintentionally doped GaN channel and AlN back barrier grown on single-crystal AlN substrate

Investigation of Surface- and Buffer-Induced Current Collapse in GaN High-Electron Mobility Transistors Using a Soft Switched Pulsed \(I-V\) Measurement

Current Collapse and High-Electric-Field Reliability of Unpassivated GaN/AlGaN/GaN HEMTs

Study of Current Collapse Behaviors of Dual-Gate AlGaN/GaN HEMTs on Si

Recoverable Current Collapse Effect of p-GaN HEMTs Under Short Circuit Stress

Current collapse suppression in AlGaN/GaN HEMTs using dual-layer SiNx stressor passivation

Investigation of the Current Collapse Induced in InGaN Back Barrier AlGaN/GaN High Electron Mobility Transistors

Effect of Fe Doping Profile on Current Collapse in GaN‐based RF HEMTs

High Breakdown AlGaN/GaN MOSHEMT with Thermal Oxidized Ni/Ti As Gate Insulator

Degradation Mechanisms of Mg-doped GaN/AlN Superlattices HEMTs under Electrical Stress

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Normally-off GaN HEMTs with InGaN P-Gate Cap Layer Formed by Polarization Doping

Improved Current Collapse in Recessed AlGaN/GaN MOS-HEMTs by Interface and Structure Engineering

Abnormal On Current Tendency in Saturation Region between High and Light Carbon Doped buffer layer in p-GaN HEMT

Suppressing Buffer-Induced Current Collapse in GaN HEMTs with a Source-Connected P-Gan (SCPG): A Simulation Study

Current Collapse Suppression by Gate Field-Plate in AlGaN/GaN HEMTs

Degradation Behavior and Mechanism of GaN HEMTs with P-Type Gate in the Third Quadrant under Repetitive Surge Current Stress