Abstract:Precision polishing of aeroengine blades involves a complex material removal process, primarily due to the presence of numerous abrasive grains bonded on the polishing tool. Therefore, understanding the surface formation mechanism at the microscale, as a result of a single abrasive grain's interaction with the workpiece, is pivotal for deciphering the collective effect of numerous abrasive actions. Since conducting single-grain cutting experiments at the microscale presents significant challenges, the finite element method (FEM) is considered an effective method for revealing microscopic physical phenomena and conducting in-depth research on cutting mechanisms. In this research, the simplified single-grain scratch experiment was conducted first, and then, the adaptive remeshing technique in Abaqus was utilized to simulate the elastic and plastic deformation of the workpiece surface during the polishing process, supplementing the physical measurement results that are difficult to achieve in the scratch experiment. The single-grain scratch experiment results show that elastic deformation of the workpiece material persists throughout the grain cutting process, and the elastic deformation FEM simulation results show that the pure rubbing phase is confined to an extremely short length after the interference occurs between the grain and the workpiece. To delve into the plastic deformation of workpiece surface in FEM simulation, the material pile-up ratio was used, and the effect of polishing variables such as cutting speed, cutting depth, and grain size on microscopic surface creation was focused on. Among them, cutting depth and grain size significantly affect the surface creation of workpiece material. In addition, the microscopic plastic deformation when the abrasive grain cut-in and cut-out phases during the polishing process is different. The outcomes of these simulations are anticipated to inform future experimental strategies and foster advancements in the development of more efficient and precise aeroengine blade polishing techniques.

Experimental Investigation of Interactions Between Abrasive Tool and Workpiece in Honing

Analysis of Material Removal in Alumina Ceramic Honing

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Effects of Horizontal Vibration Assistance on Surface Roughness in Magnetic Abrasive Finishing

Numerical analysis and experimental validation of surface roughness and morphology in honing of Inconel 718 nickel-based superalloy

Investigation on formation mechanism of surface texture and modeling of surface roughness with internal gear power honing

Simulation to Microtopography Formation of CBN Active Abrasives on a Honing Wheel Surface

Experimental Research on Optimizing Processing Parameters of Ultrasonic Polishing without Abrasive

Simulation and experimental research on residual stress of honed gear based on scratch test

Free-floating dynamic material removal mechanism of the honing process

Effect of surface polishing on the tribological performance of hard coatings under lubricated three-body abrasive conditions

The effect of hardness on the transition of the abrasive wear mechanism of steels

Tribological performance of hydrophobic and micro/nano triangle textured rake face of cutting tools

Influencing mechanism of the key parameters during bonnet polishing process

Modeling and experimental study on the grinding performance of precision diamond grinding tool with defined texture

Numerical and experimental investigation into tool-workpiece interaction in flexible abrasive tool finishing

Quantitative finite element analysis of microscopic surface formation for TC4 aeroengine blade polishing using single-grain method

Numerical and Experimental Research on the Brushing Aluminium Alloy Mechanism Using an Abrasive Filament Brush

Study on Experiments of Nano-Abrasive Polishing in Hydrodynamic Suspension Liquid

Cutting Performance of Randomly Distributed Active Abrasive Grains in Gear Honing Process

Investigation of Micro-wear and Micro-friction properties for bionic non-smooth concave components