Abstract:Belt grinding is commonly applied for precision manufacturing of difficult-to-machine materials like GH4169, owing to its satisfactory elastic grinding properties, high efficiency, and strong adaptability. Abrasive belt wear is a common occurrence during the grinding process; however, its mechanism and effect on machining quality, particularly its influence on residual stress (RS), remain unclear. In order to compensate for these shortcomings, by means of experimentation, this paper studies how the RS distribution of GH4169 plate is affected by abrasive belt wear during robotic belt grinding, and the influence mechanism is analyzed from the perspectives of grinding force and heat. Firstly, the whole life cycle of the abrasive belt is determined through a wear test, then a novel evaluating index based on relative material removal rate is proposed to quantitatively characterize the wear conditions of belt. Secondly, according to the new division criteria, abrasive belts at various wear stages are created, and then, comparative grinding experiments of the GH4169 plate are carried out. Finally, based on the experimentally measured data, this paper fully analyzes and discusses the surface and subsurface RS distribution differences of grinding traces. The experimental findings suggest that the effect of abrasive belt wear on the surface RS distribution is notable in the grinding direction, but not in the vertical direction of the grinding traces. Additionally, as the belt conditions deteriorate, the overall grinding force ratio decreases while the accumulation of grinding heat increases, which leads to the generation of surface residual tensile stress (RTS) in the grinding direction. Furthermore, as a result of the uneven heat diffusion, the surface RS along the vertical direction of the grinding traces is distributed in an approximately symmetrical manner, with higher RS values in the center and lower values on the sides. As for the subsurface RS distribution, on the whole, with the progression of belt wear, the values of the subsurface residual compressive stress (RCS) layer decrease.

Simulation and experimental research on residual stress of honed gear based on scratch test

Analytical Solution to Bending and Contact Strength of Spiral Bevel Gears in Consideration of Friction

Formation mechanism study on tooth surface of two gear finishing processes: combined theoretical and experimental approaches

Residual stresses in gear form grinding by considering carburizing heat treatment: multi-field coupled numerical simulation and experimental verification

Subsurface stress-field analysis of generating ground helical gear based on finite line-contact mixed elastohydrodynamic lubrication

Model of Surface Texture for Honed Gear Considering Motion Path and Geometrical Shape of Abrasive Particle

Investigation on formation mechanism of surface texture and modeling of surface roughness with internal gear power honing

Experimental Study on High-Speed Aviation Gear Scuffing Based on Tooth Profile and Surface Treatment Improvements

Theoretical and Experimental Study on Contact Characteristics of Spiral Bevel Gears under Quasi-Static and Large Loading Conditions

Residual Stress Distribution Design for Gear Surfaces Based on Genetic Algorithm Optimization

Cutting Performance of Randomly Distributed Active Abrasive Grains in Gear Honing Process

Simulation and experimental study of tool wear in high-speed dry gear hobbing

Experimental Investigations into Abrasive Flow Machining of Helical Gear

Effect of grinding parameters on surface quality, microstructure and rolling contact fatigue behaviors of gear steel for vacuum pump

Simulation and Experimental Verification of Die Quenching Deformation of Aviation Carburized Face Gear

Influences of tooth flank finishing after fine particle shot peening on tooth surface texture and fatigue life of vacuum carbonitrided gears

Investigation on meshing characteristics of spiral bevel gear under wear fault evolution with assembly errors

Simulation study of the punching forming process and die wear of spur gears

A comparative study of tribological performance of helical gear pair with various types of tooth surface finishing

Effect of single/multi-particle grinding parameters on surface properties of bearing steel GCr15

Analysis of abrasive belt wear effect on residual stress distribution in robotic belt grinding of GH4169