Abstract:Despite the wealth of literature on the friction and wear behaviour of ceramics, their wear mechanisms are far from well understood. The need to develop a precise understanding of the wear mechanisms is imperative for the development of better wear-resistant ceramics. Particularly in alumina ceramics, grain coarsening has been found to improve the crack growth resistance characteristics. However, if the same would be beneficial for wear resistant applications has not been systematically investigated. To evaluate if there exists a strong grain size effect on abrasive wear mechanisms in ceramics, a series of tests were conducted under severe sliding contact conditions in an alumina ceramic. Unlubricated sliding wear tests were performed on alumina of three different grain sizes, 0.7, 5 and 25 μm, using a blunt conical diamond indenter of about 100-μm tip radius as the slider at room temperature under normal loads of 8–40 N and sliding distances up to 120 mm. The abrasive wear behaviour was characterised by measuring the wear volume and wear rate as a function of normal load and sliding distance. In addition, the friction behaviour was also studied simultaneously as a function of these two variables. The wear damage mechanisms were examined using both optical and electron microscopy as well as energy dispersive X-ray spectroscopy. For a given grain size and sliding distance, the width and depth of the worn track (hence wear volume) and the frictional force all increased with normal load. These observations were more markedly displayed in the coarse-grained than in the fine-grained alumina. In the 0.7-μm fine-grained alumina, the wear process appeared to be mainly controlled by plastic deformation especially at low loads (e.g. < 10 N). At higher loads, however, both plastic deformation and grain boundary fracture processes seemed to be involved. In the 5-μm and 25-μm coarse-grained aluminas, the predominant material removal process was controlled by both intergranular and transgranular fractures.

Analysis of Material Removal in Alumina Ceramic Honing

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Wear Resistance Analysis of Plateau Honing Surface for Ceramics Mg-PSZ

Theoretical and Experimental Investigation on Inclined Ultrasonic Elliptical Vibration Cutting of Alumina Ceramics

Mechanisms of ductile mode machining for AlON ceramics

Preparation of Ultra-Fine ATC Ceramics and Analysis of Its Dry-Sliding Wear Behavior

Material removal mechanism in ultrasonic-assisted grinding of Al2O3 by single-grain scratch test

Role of composition and microstructure in the abrasive wear of high-alumina ceramics

Friction Comparison and Wear Analysis of Ceramic Cutting Tools Made from Alumina-Zirconia- Chromia Content

Synthesis, Evaluation And Characterization Of Alumina Ceramics With Elongated Grains

Multiscale Finite Element Modeling of Alumina Ceramics Undergoing Laser-Assisted Machining

Influence of mechanical properties on material deformation behavior of different ceramics in scratching

Erosion-Wear Property of α-Al2O3 Structure Ceramics with Different Experiment Parameters

Material removal mechanisms of ceramics turned by abrasive waterjet (AWJ) using a novel approach

Surface damage characteristics of AlN ceramics induced by ultra-precision grinding

Numerical analysis and experimental validation of surface roughness and morphology in honing of Inconel 718 nickel-based superalloy

Grain size effect on abrasive wear mechanisms in alumina ceramics

Effect of different abrasive particle hardness on the erosion resistant performance of α-Al2O3 ceramics

Effects of crystallization of inter-granular glassy phase on the mechanical performance of alumina ceramics

Effect of Different Abrasive Particle Hardness on the Erosion Resistant Performance of Α-Al<sub>2</sub>o<sub>3</sub> Ceramics

Evaluations on Ceramic Fracture Toughness Measurement by Edge Chipping