Abstract:Rubble stones are commonly found in many civil engineering components, such as foundations, walls. In general, rubble stone masonry walls are composed of irregular-shaped stone units and mortar. They are usually subjected to vertical and horizontal loads simultaneously and exhibit high degree of nonlinearity and discontinuity in service conditions. The combined finite-discrete element method (FDEM) was employed to investigate the mechanical behaviour of rubble stone masonry walls in this study. In order to overcome the disadvantages in both macro- and simplified micro-modelling, a detailed micro-modelling approach was utilised, i.e. stone, mortar and stone-mortar interface were considered explicitly, providing close approximation to physical structures. Stone units and mortar were discretised into linear triangular elements with finite element formulation incorporated in, and therefore, accurate estimate on structural deformation and contact forces can be obtained. Damage of rubble stone masonry was evaluated through cohesive fracture models. Numerical examples were validated, and further parametric discussions were performed. Influence of stone unit pattern, ratio of stone and strength of mortar on the failure behaviour of rubble stone masonry walls was revealed. A very good agreement between FDEM results and experimental data was observed. It was found that the higher the ratio of stone, the better the bearing capacity, and uniform-shaped stone units with regular distribution were recommended. In addition, use of mortar with both tensile and shear strengths higher than 0.2 MPa was suggested.

Finite element analysis of masonry structure based on micro-model

A Dynamic FEM-DEM Multiscale Modeling Approach for Concrete Structures

Simulation Of Collapse Process Of Masonry Walls Based On Expanded Discrete Element Method

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Macro-Modeling of Reinforced Concrete Structural Walls: State-of-the-Art

EFFECT OF MASONRY MORTAR ON THERMAL INSULATION OF AAC MASONRY

A numerical model for non-linear dynamic analysis of masonry structures subjected to ground motion

Nonlinear FEM analysis of autoclaved aerated concrete block composite masonry walls

Explicit Approach for the In-Plane Cyclic Behaviors of Unreinforced Masonry Structures Using Finite Particle Method

Research of the combined effects by temperature action and the loads on the block masonry structure

Temperature field of masonry structure considering solar radiation

3D Finite Element Simulation of Complex Static and Dynamic Fracture in Quasi-Brittle Materials

3D hybrid modelling approach combining the finite and discrete element methods: Validation based on masonry shear wall tests

Meso-scale mechanical model for mortar deformation under freeze thaw cycles

Analysis for Concrete Structures under Complicated Stress Conditions Based on General Purpose FE Software and Microplane Model

Simulating the damage of rubble stone masonry walls using FDEM with a detailed micro-modelling approach

Multi-Scale Analysis Of Damage Process For Concrete Structures

FINITE ELEMENT ANALYSIS OF HYDRATION HEAT TEMPERATURE FIELD IN CONCRETE FOUNDATION OF TONGBAI POWER STATION

A Discrete Macro-Element Method (DMEM) for the nonlinear structural assessment of masonry arches

Analytical modeling of masonry load-bearing walls

Study on the mechanical behavior of millennium-ancient bricks based on microscopic characteristics