Experimental Research and Finite Element Analysis on Joints of Sun Valley Steel Structure for the Expo Axis Project

CHEN Min,XING Dong,ZHAO Yang,SU Liang,DONG Shilin,WANG Dasui,FANG Wei,ZHANG Anan

2010-01-01

Abstract:A new type of joint was adopted in the single-layer lattice structure of the Sun Valleys for Expo Axis project. The design idea of the new joints was that only upper and lower flanges of rectangular steel tube members and webs of two main members with maximum internal forces were welded to the core zone of the joint. According to processing technology, the core zone has two types of configuration: two end plates connected with stiffener and solid cylinder. Ten typical full-scale joints selected from three Sun Valleys were tested, in order to investigate the structural behavior, failure mechanism and load bearing capacity of the joints so that the safety and reliability of joints could be assured, and to verify the joints fabricated with different processing technologies could meet the design requirement. Test results indicate that the joints adopted in the project have sufficient safety reserves and can meet the requirement of ' strong-joints/weak-member' concept. For joints with a solid cylinder as the core zone, the stress level is lower and stress concentration is relatively mild. Results from finite element modeling of the test joints indicate that, the elasto-plastic nonlinear analysis considering large deformations can simulate the bearing behavior of the joint satisfactorily.