Abstract:The study investigated the microstructural characteristics, Laves phase dissolution kinetics, and the homogenization kinetics of Ti, Nb, Mo elements, as well as the hot deformation behavior of ERNiCrMo-3 alloy under different homogenization degrees. The results showed that the precipitated phases in the as-cast ERNiCrMo-3 alloy primarily included carbonitrides (Nb,Ti)CN, δ phase, and Laves phase. Cr and Fe elements exhibited negative segregation, while Al, Mo, Nb, and Ti elements showed positive segregation into the interdendritic regions. The temperature required to completely eliminate the δ phase in the as-cast ERNiCrMo-3 alloy was between 1050 °C and 1100 °C. The dissolution temperature of the Laves phase was above 1200 °C, with a diffusion activation energy of 186.184 kJ/mol. The compound phases of nitrides and Laves phases in the alloy were found and dissolved upon exceeding 1150 °C, and spinel Mo 2 Nb 2 O 6 as well as oxide Cr 2 O 3 also formed within the alloy after the temperature exceeded 1150 °C. The diffusion activation energies for Ti, Nb, Mo elements, QTi , QNb , QMo , were 265.48, 231.85, 275.69 kJ/mol, with diffusion constants D0 of 2.4E-1, 6.15E-3, 4.4E-1 cm 2 /s, respectively. The low diffusion coefficient and activation energy of Nb element serve as the limiting mechanisms in the homogenization process of the as-cast ERNiCrMo-3. Furthermore, The recrystallization mechanism involved particle-stimulated nucleation initially, transitioning to continuous dynamic recrystallization. The degree of dynamic recrystallization within the ERNiCrMo-3 alloy exhibits an initial decrease followed by an increase. Homogenization enhances hot deformation compatibility and reduces the propensity for hot deformation-induced cracking within the alloy.

Homogenization of Nitrogen in Fe-3Si Alloy at High-Temperature Annealing Process

Thermal Nitridation Kinetics of Silicon Wafers in Nitrogen Atmosphere During Annealing

Kinetics of Nitrogen Indiffusion in Czochralski Silicon Annealed in Nitrogen Ambient

The behaviour of nitrogen in silicon during heat treatment at high temperature

Direct-Nitridation of Silicon by Heat-Treating at High Temperature in Nitrogen Ambience

An investigation on nitrogen uptake and microstructure of equimolar quaternary FeCoNiCr high entropy alloy after active-screen plasma nitriding

Preparation of Si3N4–TiN–SiC composite by partial substitution of Ti–Si–Fe alloy for Si under N2 atmosphere

Isothermal decomposition behavior of the high nitrogen concentration γ-Fe[N] prepared from pure iron

Microstructure Evolution and Homogenization Kinetics of 15Cr–30Ni–Fe Heat‐Resistant Alloy

Corrosion Behavior of Newly Designed Fe-Ni-Base Alloys in High-Temperature CO2 at 700 °C

Nitridation of Atomic-Layer-deposited HfO2/Al2O3 Stacks by NH3 Annealing

Effects of High-Temperature Annealing Atmosphere on the Secondary Recrystallization Behavior and Magnetic Properties of Fe-3.2%Si-0.055%Nb Grain-Oriented Silicon Steel

Microstructural Evolution of a Selective Laser Melted FeCoCrNiMn–(N,Si) High‐Entropy Alloy Subject to Cold‐Rolling and Subsequent Annealing

Microstructure evolution in a Fe-Ni-Si alloy during heat treatment and electron irradiation

Influence of Nitrogen Content on the Microstructure Evolution and Oxidation Resistance toward Ambient Air of CrAlSiN Coatings Deposited by FCVAD Technique

Thermodynamic Studies of the Fe-Cr-C-N System by Emf Measurements

Bainite Formation in a Carbon-Free Fe–Cr–N System

The influence of homogenization on the microstructure and high-temperature mechanical properties of ERNiCrMo-3 alloy

Atomic Diffusion in the Interface of Fe/Si Prepared by Magnetron Sputtering

Unusual Iron Nitride Formation Upon Nitriding Fe-Si Alloy

Effect of Holding Time of Decarbonization Annealing on Recrystallization in Fe-3.2%Si-0.047Nb% Low-Temperature Oriented Silicon Steel