Abstract:In three-roll planetary rolling (TRPR), the tubular billet undergoes large deformation of 90% under the state of compression and shear by the constraint of three rolls. In this process, the microstructures and the properties of the rolled tubular billet will change dramatically because of the dynamic recrystallization induced by the large enough deformation. As it is all known, the obtaining of structure profile with high precision and efficiency becomes the investigation foundation of the microstructure. However, the structure profile of the tubular billet is still difficult to be described exactly because of the complex deformation which will be significantly influenced by plenty of process parameters. Therefore, the finite element method (FEM) was utilized to investigate the influence of the adjustable angles including the inclined angles and the deflection angles on the structure profile of rolled workpieces. Furthermore, the machine learning was subsequently utilized to learn the correlation between the process parameters and the structure profile and provide further prediction. In addition, the theoretical analysis model was established and optimized to reveal the relationship between the process parameters and the axial extension coefficient λ which is calculated to represent the deformation degree along to the axial direction. It is concluded that the inclined angles and the deflection angles of rolls are known to be the one of key factors affecting the structure profile of rolled tube. The prediction model is established and applied to efficiently estimate the structure profile under any process parameters including different initial size of billets, the inclined angles, and the deflection angles. This investigation will contribute to exact controlling of the microstructure of the copper tube by quantitative means.

Finite element analysis on the roll milling process of twisted oblate tube

Numerical Simulation of the Roll Forming Process of Aluminum Folded Micro-channel Tube

Elastic-plastic FEM analysis of roll forming process of secondary tubes from primary cyclic tubes

Finite element simulation of roll forming process based on over-bend defect control of shaped tube

Finite Element Simulation of Two-pass Drawing Process of an Aluminum Tube from Circular to Rectangular Section

Numerical Simulation and Experimental of Forming Defects in Roll-Bending Process for Z-Shaped Profiles With Large Cross-Section

Deforming Mechanism of Non-Mandrel Drawing Process of Circular Aluminium Tube by Simulation

Simulation of a multi-stand roll-forming process for thick channel section

Finite Element Simulation on the Spin-Forming of the 3d Non-Axisymmetric Thin-Walled Tubes

Three-dimensional Finite-Elements Modeling and Simulation of Rotary-Draw Bending Process for Thin-Walled Rectangular Tube

Three-dimensional FE simulation of multi-strokes cold pilgering of TA18 titanium alloy tube: I theoretical analysis, modeling and validation

Finite element analysis of circle-to-rectangle roll forming of thick-walled rectangular tubes with small rounded corners

Investigation on the Structure Profile of Precise Copper Tube by Three-Roll Planetary Rolling Based on Finite Element Simulation Assisted by Machine Learning

Numerical Simulation on Optimization of Process Parameters for Free Bending of Metal Tubes

Numerical Simulation and Parameters Analysis for Roll Forming of Martensitic Steel MS980

Finite element synthesized analysis of the forming process of spiral welded pipe

Whole process simulation of roll forming using dynamic explicit finite element method

Finite-Elements Modeling and Simulation of Electrically-Assisted Rotary-Draw Bending Process for 6063 Aluminum Alloy Micro-Tube

Finite Element Analysis of Temper Rolling Process

Three-Dimensional Fe Simulation of Multi-Strokes Pilgering Cold Roll of Ta18 Titanium Alloy Tube: Ii Analysis of Plastic Deformation Behavior

Research on the Dynamic Simulation of the Thin-Walled Tube Straightening Process