Abstract:Resistive current is an important AC measuring procedure of MOV(metal oxygen varistor).There are various measuring methods of resistive current,which includes hardware compensation method,harmonic analysis method,VCCT(variable coefficient compensation technique) and multi-coefficient compensation method.Currently,VCCT is a general method for measuring resistive current of MOV,but the compensation coefficients of VCCT are derived by the base current and voltage,the capacitive humonic components can not be compensated,the zero points of the resistive current and the added voltage of MOV can not superpose,and distortion in the V-I characteristic curve occurs,so the measuring error of MOV resistive current is caused inevitably.HCT(harmonic compensative technique) for measuring the resistive current of MOV is put forward,the capacitive harmonic current components can be subtracted from the leakage current.The quasi-synchronous sampling technique and DFT(disperse Fourier transform) technique are adopted to deal current and voltage signals,then the measuring error of signals,which include the amplitude and phase measuring errors of voltage and resistive current of MOV,is less than 5‰,effectively minimizing the spectrum leakage caused by non-integer period sampling.The experimental results show that the method can eliminate the resistive current measuring errors which are caused by harmonic voltage and lesson the sampling error caused by the fluctuation of power frequency,it can compensate the capacitive component of total leakage current of MOV almost completely,and it can make the resistance current has almost same phase as the acted voltage.The results of adopting the test and calibration circuit of standard resistance and capacitor and comparing the test results with FLUKE-45 digital multimeter reveal that the relative measuring error of resistive current of MOV is less than 1%.The measuring method can measure the resistive current precisely.

Simulation on Dynamic Characteristics of MOV Under 8/20 μs Impulse Current Generators with Different Source Impedances

Investigation into the Equivalent Circuit of MOV and the Determination of Its Parameters

The Statistic Analysis on Principal Electric Parameters of MOV for Surge Arrester

Parallel Impulse Current Shunt Performance of Multiple MOVs for 500kV Series Compensation

Impulse Life Evaluation Method of MOV Based on Weibull Distribution

Investigation of the Effects of Multi-Waveform Multi-Pulse Impulse Currents on Mov for Class I Spd Through Operating Duty Tests

Investigation of Impulse Aging of Energy-Absorption Elements for Hybrid DC Circuit Breakers

Impedance Characteristics of Metal Oxide Varistor under Different Pulses

Assessment of MOV Deterioration under Energized Conditions

The Analysis of Equivalent Circuits of Metal Oxide Surge Varistor under Different Surge Currents

Research on the Relationship Between the Voltage and the Resistive Current,Capacitive Current in Low Current of MOV

Applicability Analysis of Simulation Model of Metal Oxide Arrester and Experimental Study

MOV Failure Modes and Microstructural Characteristics Under Operating Duty Tests With Multiwaveform Multipulse Currents

Accuracy Analysis of Metal-Oxide Arrester Simulation Models Considering the Energy Absorption Estimation Under Impulse Currents With Different Steepness

Dynamic Characteristics and Cascaded Coordination of Limiting-Type SPDs under Subsequent Negative Strokes

Analysis of MOV Simulation Model Based on ATP-EMTP

Experimental Validation of Moa Simulation Models for Energy Absorption Estimation under Different Impulse Currents

Improved Testing Method of 10/350 Μs Impulse Current Tests

Investigation of Harmonic Compensation Technique for Measuring MOV Resistive Current

De-Excitation Simulation of 1 000 MW Steam-turbine Generator after Abrupt Three-phase Short Circuit

Simulation Analysis for Fault States of 2.5 MV Electro-Magnetic Pulse Driver with Fast Rise Time