Abstract:MOA (Metal Oxide Arrester) has been widely used in the world because of its excellent nonlinearity, long-lasting anti-aging properties and excellent overvoltage protection performance. The performance degradation of the MOV occurs in the long-running process because of environmental reasons, so the online monitoring system for the MOA has a great significance for the stable operation of the power system. With the improvement of MOA manufacturing technology and the adjustment of the resistance sheet formula, the state parameter's characteristics of MOA had changed obviously. The traditional MOA state detection method could not guarantee the validity and correctness of the test. MOV (Metal Oxide Varistor) is the core component of MOA. The state change of MOV can partly reflect the changes of MOA. In this paper, six typical ultrahigh pressure MOV from two manufacturers are experimented separately to obtain resistive fundamental harmonic leakage current, resistive third harmonic current and continuous current of the MOV under different conditions. We extract the most obvious changes in the current component as a reference that can detect the fault type of MOA. In this paper, we study the three factors: Electric load rate, temperature and damp. The experimental results show that: (1)When the continuous operating voltage changes, the resistive third harmonic currents of the MOV is the highest of the three leakage currents.(2) The change of continuous current caused by damp is related to the surface condition of MOV, if the surface of MOV is in good condition, the continuous current does not change significantly; if the surface of the MOV damaged, the continuous current resistive component of MOV will change significantly (3) In the MOV temperature test, the MOV heated from 20 degrees Celsius gradually to 80 degrees Celsius, we tested the resistive fundamental harmonic leakage current, the resistive third harmonic current and the continuous current of the MOV. With the change of the temperature, the resistive third harmonic current and the continuous current change not obviously. At the same time, the resistive fundamental harmonic leakage current changed obviously, So the resistive fundamental harmonic leakage current can reflect the temperature change of the MOV.

Investigation of Harmonic Compensation Technique for Measuring MOV Resistive Current

Compensation of Current Measurement Error in PMSM Drives Based on Virtual Windings

A Differential Compensated Air Coil Current Sensor for Switching Current Measurement of Power Devices.

Current Measurement Error Compensation Based on Modified Multiple Complex-Coefficient Filters in PMSM Drives

Research on Automatic Compensation of Remnant-voltage of GMR Eddy Current Probe

Investigation into the Equivalent Circuit of MOV and the Determination of Its Parameters

Research on the Relationship Between the Voltage and the Resistive Current,Capacitive Current in Low Current of MOV

A Novel Current-Based Identification Method for Dynamic Performance of High-Speed On/off Valve

A Simple Method for Compensating Harmonic Distortion in Current Transformers: Experimental Validation

A NEW METHOD FOR REAL-TIME DETECTING HARMONICS AND REACTIVE CURRENTS IN SINGLE-PHASE CIRCUIT

Research on leakage current characteristic of metal oxide varistor

Simulation on Dynamic Characteristics of MOV Under 8/20 μs Impulse Current Generators with Different Source Impedances

A Nonintrusive Current Sensor Gain Tuning Method for Interior Permanent Magnet Synchronous Motor Drives Using Controlled Short-Circuit Tests

Moa Resistive Current On-Line Monitoring and Expert Diagnosis System

Accurate detection for harmonics and reactive currents in the case of unsymmetrical three-phase voltages

Detection for Abnormal Commutation Process State of Converter Based on Temporal and Amplitude Characteristics of AC Current

Comparative Study of Harmonic Current Suppression Control Strategies for Six-Phase DC-Biased Vernier Reluctance Machines

A high accuracy current comparator with electronic compensation

DYNAMIC RESONANCE ADJUSTMENT DEVICE OF ARC-SUPPRESSION COIL WITH MAGNETIC BIAS

Compensation Method for Current Measurement Errors in the Synchronous Reference Frame of a Small-Sized Surface Vehicle Propulsion Motor

Research on the Methods of Measuring High Frequency Small Current in Large Power Frequency Current by Current Transformer