Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Influence of Revised Kinetics Model on DPF's Thermal Regeneration

Influence of Incoming Flow Conditions on DPF Thermal Regeneration

Modeling and Simulation of Commercial Catalytic Reformers

Kinetic and Regenerator Modeling of the Coke Combustion in the Moving Bed MTP Process

Numerical Simulation of Diesel Particulate Filter Regeneration Considering Ash Deposit

Multi-channel Simulation of the Regeneration of Diesel Particulate Filters

Simulation and Optimization of Mathematical Model Based DPF Regeneration Control Strategy

A Study on the Compound Regeneration Control Strategy for DPF Using Burner and DOC

Integrated Gas and Solid Model to Determine the Flow Performance in the SCR Reactor

Asymptotic Analysis Soot Model and Experiment for a Directed Injection Engine

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

Study on regenerative exothermic process in ash containing DPF structure based on lattice Boltzmann method

Study on the Evolution of Physicochemical Properties of Carbon Black at Different Regeneration Stages of Diesel Particulate Filters Regenerated by Non-Thermal Plasma

Investigations on a new C-GPFs with electric heating for enhancing the integrated regeneration performance under critical parameters

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Nonlinear model predictive control(NMPC) of diesel oxidation catalyst (DOC) outlet temperature for active regeneration of diesel particulate filter (DPF) in diesel engine

Experimental and Simulation Study on Diesel Spray Oxidation During Active Regeneration of DPF

Study on Characteristics and Control Strategy of Diesel Particulate Filters Based on Engine Bench

Experimental investigation of diesel soot oxidation reactivity along the exhaust after-treatment system components

Full course evolution characteristics of DPF active regeneration under different inlet HC concentrations

Control-Oriented Modeling and Observer-Based Estimation of Solid and Gas Temperatures for a Diesel Engine Aftertreatment System