Abstract:Much of surplus ammunition stockpile inevitably requires demilitarized processing technology in the explosives industry. For the safe waste treatment and recycle, the thermoplastic polymer bonded explosive (PBX) can effectively reduce the military cost and non-conforming products. In addition, the thermoplastic PBX has excellent application prospect as the future explosive due to the good mechanical properties and insensitivity. However, for high solid content, most of thermoplastic PBXs still maintain a considerable viscosity even in high-temperature melting state, rendering traditional casting process unsuitable. In this study, a measuring method was adopted to accurately obtain the correlation of Pressure-Volume-Temperature (PVT) for the simulative materials of thermoplastic PBX at first. The equations of state for PVT and viscosity model were then created, which are of great significance in single screw extrusion. An experiment system of single screw extrusion was designed to implement the molding process considering the poor liquidity problem of the thermoplastic materials. Excellent molding stability (rho<0.5 % variation) was achieved for the extrusion system. Moreover, a numerical investigation was also performed. Good agreements were yielded by comparing the simulation data and experimental results. The effects of operational parameters, i. e., the entrance pressure, barrel temperature and rotation speed on molding process of the thermoplastic materials were investigated in detail. The wall shear stress decreases with the feed inlet well sealed whereas the maximum temperature rise increases a little due to limited thermal diffusion. Either increasing temperature or decreasing rotation speed is beneficial to overall process safety. However, production cycle and attainable molding density also need to be considered at the same time. Furthermore, the process parameters should be optimized on the basis of the PVT and viscosity properties of material in practice. The investigations above can be a better guidance for the development and implementation of thermoplastic PBXs molding process.

Extrusion process of polymer under vibration force field at low temperature in ball-screw-electromagnetism-dynamic extruder

Experimental Study of High-Frequency Vibration Assisted Micro/Mesoscale Forming of Metallic Materials

Energy Dissipation in Polymer Injection Moulding under Vibration Force Field

Theoretical and Computational Analysis on the Melt Flow Behavior of Polylactic Acid in Material Extrusion Additive Manufacturing under Vibration Field

Experimental Study on Improving the Mechanical Properties of Material Extrusion Rapid Prototyping Polylactic Acid Parts by Applied Vibration

Study on Mechanical Properties and Molecular Aggregate of the Dynamic Extrusion Polymer Filling System

Study on the Effect of Axial Vibration of Screw in Plasticating Process (Extrusion Part)

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

Numerical modelling of the viscoelastic polymer melt flow in material extrusion additive manufacturing

Design and Application of Extrusion Swell Collecting System under the Vibration Force Field

Research on Modeling of Hot Embossing Polymeric Microfluidic Chip

Experimental and Numerical Analysis of Single Screw Extrusion Process for Thermoplastic PBX Based on PVT Properties

The Design and Simulation of Vibrate Impact Extrusion Die

Effect of Vibration Parameters on Properties of Polypropylene in Dynamic Plasticizing Process

Effect of speed sinusoidal pulsating enhancement on the mixing property of plastic machinery

Key technology of plastic forming with low frequency vibration

Heat Transfer and Viscous Polymer Melting Capacity Correlation in Self-Controlled Torsion Induced Extrusion

Experimental study on the forming process of spline by frequency and amplitude modulated axial vibration extrusion

In situ X-ray diffraction and thermal simulation of material extrusion additive manufacturing of polymer

The Design and Realization of Extrude Swell Collecting System Under the Vibration Force Field

Improvement in an Analytical Approach for Modeling the Melting Process in Single-Screw Extruders