Abstract:The process parameters of the axial-pushed incremental rolling process are studied in this paper to solve the problems in present production process of spline shaft. Firstly, the principle of the axial-pushed incremental rolling process is introduced. Based on the material of 42CrMo, the simplified finite element models of the process are established up. Then, the effects of process parameters and the material flow behavior during the process are investigated by finite element analysis (FEA). After that, the reasonable process parameters during the novel process (die angle 9°, feed speed 0.5 mm s−1, and speed of rolling die 25 r min−1) are determined to meet a good balance between the forming force, product precision, and processing efficiency. To verify the determined parameters, validation tests with the blank material 42CrMo were carried out on an axial-pushed incremental rolling equipment. The experimental results (tooth shape and forming force) show a good agreement with FEA results. Through the dimension measurement, the addendum and root circle diameters of formed spline shafts are 51.61, 51.72, and 51.66 mm and 48.66, 48.78, and 48.69 mm, respectively. The formed spline shafts with the determined process parameters reach to the requirement of direct use (required addendum circle diameter 51.56~51.75 mm, required root circle diameter 48.5~48.7 mm). Finally, the feasibility of the determined process parameters with other materials (no. 20 and no. 45 steel) is investigated. The dimensions of the formed spline shafts just slightly deviate from the theoretical value. This problem is solved by adjusting the feed speed and the speed of rolling die. Therefore, the determined process parameters of the axial-pushed incremental rolling process are usable for the production of spline shaft.

Experimental study on the forming process of spline by frequency and amplitude modulated axial vibration extrusion

Experimental Study of High-Frequency Vibration Assisted Micro/Mesoscale Forming of Metallic Materials

Effects of superimposed high-frequency vibration on deformation of aluminum in micro/meso-scale upsetting

Study on Metal Forming Patterns of the Ultrasonic Vibration Assisted Upset-extruding Process

Experimental Research on Oscillating Extrusion of Splined Shaft

The Experimental Study of Axial In-feed Incremental Rolling Process of Spline Shaft

Improvement of Axial Forging Process for Spline Shaft by Die Design

Effect of Variational Friction and Elastic Deformation of Die on Oscillating Cold Forging for Spline Shaft

Finite element modeling and analysis for the integration–rolling–extrusion process of spline shaft

Applying Low-Frequency Vibration For The Experimental Investigation Of Clutch Hub Forming

The Design and Simulation of Vibrate Impact Extrusion Die

Influence of ultrasonic vibration on forming force of 1060 aluminum sheet single point incremental forming

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Study on Warm Forming Effects of the Axial-Pushed Incremental Rolling Process of Spline Shaft with 42crmo Steel

Simulation Study on the High-Speed Single-Point Accumulation Forming Process of Involute Spline

Process Parameter Determination of the Axial-Pushed Incremental Rolling Process of Spline Shaft

Deformation Mechanism and Performance Improvement of Spline Shaft with 42crmo Steel by Axial-Infeed Incremental Rolling Process

Experimental Study on the Axial-Infeed Incremental Warm Rolling Process for Spline Shaft Production

Simulation and Experimental Study of Ultrasonic Vibratory Grinding of Internal Splines

Experimental and Numerical Study of Forming Limit in 1060 Aluminum Ultrasonic Vibration Single Point Incremental Forming

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling