Semi-analytical torque modeling of Ti-6Al-4V-alloy internal trapezoidal thread extrusion forming with an emphasis on low-frequency torsional vibration

Yuan-Jun Hou,Dun-Wen Zuo,Yu-Li Sun,Ze-Nan Liao

DOI: https://doi.org/10.1016/j.jmatprotec.2020.116812

IF: 6.3

2020-12-01

Journal of Materials Processing Technology

Abstract:<p>Conventional cold extrusion is generally considered to be less practical for trapezoidal threads, requiring a relatively large form tapping torque. The machining of it is always based on cutting, but the actual demands of high strength and long life have brought this process to its limits. These requirements drove the present work, which proposes a new process for the fabrication of a Ti-6Al-4V-alloy trapezoidal thread using low-frequency torsional vibration extrusion (LTVE) through a forming tap. A semi-analytical model of torsional vibration extrusion with friction was established by solving the problem of mechanical friction and slip-line field. The influence of low-frequency torsional vibration on the form tapping torque was studied, and the total amounts were determined quantitatively. The conclusion shows that the total tapping torque was composed of the positive pressure load and the friction load on the forming tap. The friction load was generated by the tool/workpiece friction, which is the largest component, accounting for more than 90 %. The introduction of vibration can reduce the friction in the thread form tapping so as to obtain high rheological properties, which is applicable for the low-frequency stage. Finally, a mechanical LTVE tapping excitation device was proposed based on this process method, and an experimental prototype that can meet the requirements of titanium alloy trapezoidal thread machining was developed. Experimental verification indicated that the LTVE forming process had reduced the total form tapping torque. It also proved the method's overall reliability and effectiveness and the underlying insights needed to guide the thread manufacturing.</p>

materials science, multidisciplinary,engineering, manufacturing, industrial

What problem does this paper attempt to address?

The paper attempts to address the issue of high forming torque encountered when machining trapezoidal internal threads on titanium alloy materials. Traditional cold extrusion forming processes are not practical for trapezoidal threads because they require large forming torque. Additionally, due to the low thermal conductivity and high deformation resistance of titanium alloys, traditional machining methods are difficult to meet the requirements of high strength and long life. Therefore, this paper proposes a new machining method—Low-Frequency Torsional Vibration Extrusion (LTVE) forming technology, which introduces low-frequency torsional vibration to reduce forming torque and improve the rheological properties of the material, thereby achieving efficient machining of trapezoidal internal threads in titanium alloys.

Specifically, the paper establishes a semi-analytical torsional vibration extrusion model to study the effect of low-frequency torsional vibration on forming torque and quantitatively determines the composition of the total forming torque. The research results show that the total forming torque is mainly composed of normal pressure load and friction load, with the friction load being dominant, accounting for more than 90%. By introducing vibration, the friction during the thread forming process can be reduced, thereby achieving higher rheological properties, suitable for the low-frequency stage. Additionally, the paper proposes a mechanical LTVE forming excitation device and develops an experimental prototype to verify the effectiveness and reliability of the method.