Abstract:The hot disk transient plane source (TPS) method is a widely used standard technique (ISO 22007-2) for the characterization of thermal properties of materials, especially the thermal conductivity, k. Despite its well-established reliability for a wide variety of common materials, the hot disk TPS method is also known to suffer from a substantial systematic errors when applied to low-k thermal insulation materials. Here, we present a combined numerical and experimental study on the influence of the geometry of hot disk sensor on measured value of low-k materials. We demonstrate that the error is strongly affected by the finite thickness and thermal mass of the sensor's insulation layer was well as the corresponding increase of the effective heater size beyond the radius of the embedded metal heater itself. We also numerically investigate the dependence of the error on the sample thermal properties, confirming that the errors are worse in low-k samples. A simple correction function is also provided, which converts the apparent (erroneous) result from a standard hot disk TPS measurement to a more accurate value. A standard polyimide sensor was also optimized using both wet and dry etching to provide more accurate measurement directly. Experimentally corrected value of k for Airloy x56 aerogel and a commercial silica aerogel using the numerical correction factor derived based on the standard TPS sensor is in excellent agreement with the directly measured value from the TPS sensor using the optimized polyimide sensor. Both of these methods can reduce the errors to less than 4% as compared to around 40% error of overestimation from raw values measured with the pristine sensor. Such results show that both the numerical correction to a pristine senor or an optimized sensor are capable of providing highly accurate value of thermal conductivity for such materials.

Effects of heat capacity of a Hot disk probe on thermal conductivity measurement

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

SUPPLEMENTARY EXPERIMENT INVESTIGATION ON THERMAL CONDUCTIVITY MEASURED BY STEADY-STATE PLATE METHOD

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

The Boundary Induced Error on the Measurement of Thermal-Conductivity by Transient Hot-Wire Method

Analysis of errors in the evaluation of parallel transient hot wire measurements by means of line heat source fits

Long Short Hot-Probe Method for Determining Thermophysical Properties

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition

Analysis of thermal plasma diagnostics based on enthalpy probe system

A convenient method of measuring the thermal conductivity of biological tissue.

Automatic Algorithm Applied for Calculating Thermal Conductivity by Transient Plane Source Method

Analysis of radiation effect on thermal conductivity measurement of semi-transparent materials based on transient plane source method

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

Measurement Methods and Applications for Thermophysical Properties at Micro/Nanoscales

A high-precision method to measure thermal conductivity of solids using reversible heat flux

A Micromachined Device Using Transient Hot-Wire Method For High Accuracy Thermal Conductivity Measurement Of Semi-Rigid Materials

Experimental Thermal Conductivity Measurement of Hollow-Structured Polypropylene Material by DTC-25 and Hot Box Test

Quantitative evaluation of the natural convection effect on thermal conductivity measurement with transient plane source method

Accurate heat capacity determination of solids and liquids using a heat conduction calorimeter

Experimental Study on Thermal Conductivity Measurement of Wet Unconsolidated Porous Media