Real-time Monitoring of Dosimetry and Image Quality During Digital Radiology Examinations

孙建忠,王志康,章伟敏,揭丽勇

DOI: https://doi.org/10.3760/cma.j.issn.1005-1201.2009.12.008

2009-01-01

Abstract:Objective To explore the feasibility of real-time monitoring exposure dose and image quality by using the data stored in the DICOM image archive of direct digital radiography system.Methods Model TO.16 was exposed,the current increased gradually from 0.5 to 125 mAs.The displayed number of model A(diameter 11.1 mm),D (diameter 4.0 mm) and J(diameter 0.7 mm) were recorded,and the detect factors(H_T)was also calculated.Images were sent to workstation before the end of DR examination.An automatic procedure was implemented to extract dose data and exposure parameters from the DICOM header file. Maximum,minimum and 3rd quartile values were preinstalled. Mean values exceeding the threshold trigger alarm signal to guide radiologist to explore the cause.Results When the current of point A was less than 10 mAs and the current of point D and J were less than 16 mAs,the detect factor(HT)increased with the rise of current.While point A located within 10-100 mAs,point D and J within 16-100 mAs,the detect factor did not rise.Totally,66 alarm signals were observed among 5120 exposures including 21 alarm signals triggered by the exceeded dose limit,among which,7 signals triggered by manual control overdose,4 signals triggered by selection faults related to auto exposure control (AEC),9 signals resulted from the increased exposure field and one unclear signal associated with the instability of AEC during short period.The other 45 alarm signals were triggered by the below dose limit due to the examination position not at the centre.Conclusion The adopted method can detect inappropriate exposure dose and impaired picture quality caused by technician or equipment,therefore it can real-time manage exposure dose and image quality automatically.