Abstract:THFG is an advanced technology to manufacture tubular components with complex cross-sections. Meanwhile, curved axis often exists in such components, which is formed by pre-bending steps before THFG. However, the effect of pre-bending on the subsequent THFG, especially on the critical internal pressure required to inhibit wrinkling, has not been clarified yet. Considering the difference in the cold work-hardening and the thickness distribution caused by pre-bending, the change rule between the critical internal pressure and the hoop strain was re-established based on the energy method. It is found that the cold work-hardening has a great influence on the change rule. Subsequently, by solving the three-dimensional mechanics condition of single and double curvature differential segments respectively, the distribution of hoop strain after THFG was obtained by combining pre-bending. Pointing out that the initial thickness has an obvious effect on the hoop strain distribution, while the cold work-hardening is almost negligible. The maximum hoop strain was brought into the change rule between critical internal pressure and hoop strain, then, a new analytical model between the critical internal pressure and the punch stroke considering pre-bending was built. The critical internal pressure considering pre-bending is determined by that of outer straight wall, and its value is always greater than the critical internal pressure without considering pre-bending under the same punch stroke. With the reduction of bending radius, the critical internal pressure distinction between considering and not considering pre-bending will be greater. Moreover, the smaller the friction coefficient also will lead the distinction to be more prominent. In this work, our proposed new prediction model of critical internal pressure is meticulously demonstrated, which can improve the accuracy by 74% at least when existing the pre-bending.

Effect of Internal Pressure on Thin-Walled Tubes Bending with Internal Pressure

Influence of Internal Pressure on Hydro-Bending of Thin-Walled Aluminum Alloy Tube

Effect of Internal Pressure on Corner Radius and Thickness Distribution of Shear Hydro-Bending of 5a02 Aluminum Alloy Tube

Influence of Tube Ends Constraint on Hydro-Bending of Thin-Walled Aluminum Tube

Buckling of Cold-Stretched Cylindrical Vessels under External Pressure: Experimental and Numerical Investigation

Axial Stress Analysis for the Hydro Bending Process of Double-Layered Tube

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

The Bulging Behavior of Thick-Walled 6063 Aluminum Alloy Tubes under Double-Sided Pressures

Investigation into Wrinkling Behavior of Thin-Walled 5a02 Aluminum Alloy Tubes under Internal and External Pressure

The research on the critical loading path of thick-walled pipes under external pressure and cyclic bending

Behavior of Thin-Walled Dodecagonal Section Double Skin Concrete-Filled Steel Tubes under Bending

Additional Bending Moment of Thick-Walled Elliptical Tube under Internal Pressure

An Investigation into the Effect of Pre-bending on the Tube Hydro-forging Technology

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Numerical Research on High-Strength Rectangular Section Steel Tube in Rotary-Draw Bending

Simulation and the Experimental Analysis on Wrinkling at Flat Tube Rotary Bending In-Plane

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Limit bending moment for pipes with two circumferential flaws under combined internal pressure and bending

On the Collapse Failure of Dented Pipes under Bending Moment and External Pressure

Experimental investigation of initial internal pressure on hydroforming multi-stepped shaft