Abstract:Yttria-stabilized zirconia (YSZ) electrolyte coatings for planar solid oxide fuel cell were prepared on porous NiO–YSZ substrates with a high deposition rate of 1μm/min by electron beam physical vapor deposition (EB-PVD) technique. A sol infiltration treatment was conducted to improve the gas tightness of EB-PVD coating through infiltrating the coating sample in a zirconium and yttrium sol bath followed by a heat treatment. The parameters of heat treatment were determined according to thermogravimetric analysis and X-ray diffraction result of precursor powders obtained from the sol. After infiltration treatment, the sol had penetrated into the coating and the impregnation depth reached up to 3μm. At the same time, the intergranular pores and gaps of as-deposited coating had been stuffed by the decomposed products from the sol. The coefficient of gas permeability dropped from 6.78×10−5cm4N−1s−1 for as-deposited coating to 6.54×10−6cm4N−1s−1 for the coating after eight times of infiltration treatment. Then unit cells were assembled and the open circuit voltage increased from 0.820V for unit cell with as-deposited electrolyte coating to 1.036V for cell with electrolyte coating after eight times of infiltration treatment. For unit cell with electrolyte coating after eight times of sol infiltration, the maximum output powder density of 150mW/cm2 was obtained at 800°C.

Preparation of YSZ Electrolyte Film by Electrophoretic Deposition under Constant Voltage

YSZ Thin Films Prepared by a Novel Powder Coating Process on Porous NiO-YSZ Cermet

A simple and easy one-step fabrication of thin BaZr0.1Ce0.7Y0.2O3−δ electrolyte membrane for solid oxide fuel cells

Preparation of YSZ thin films for intermediate temperature solid oxide fuel cells by dip-coating method

Deposition of Y2O3 stabilized ZrO2 thin films from Zr(DPM)4 and Y(DPM)3 by aerosol-assisted MOCVD

Study on Preparation of YSZ Film by Electrophoretic Deposition under Constant Current and Its Application in SOFCs

A Facile and Environment-Friendly Method to Fabricate Thin Electrolyte Films for Solid Oxide Fuel Cells

Electrophoretic deposition of YSZ thin-film electrolyte for SOFCs utilizing electrostatic-steric stabilized suspensions obtained via high energy ball milling

Study of YSZ Electrolyte Film Fabricated by Suspension

Preparation of YSZ Film by EPD and Its Application in SOFCs

Electron beam physical vapor deposition of YSZ electrolyte coatings for SOFCs

Preparation of Yttria-Stabilized Zirconia(ysz)films by an Electrophoretic Deposition Method

Yttria-stabilized zirconia thin film electrolyte deposited by EB-PVD on porous anode support for SOFC applications

Fabrication and Performance of Anode-Supported YSZ Films by Slurry Spin Coating

Preparation of YSZ electrolyte coatings for SOFC by electron beam physical vapor deposition combined with a sol infiltration treatment

Dense YSZ electrolyte films prepared by modified electrostatic powder coating

Preparation and Performance of YSZ Thin-Film by Centrifugal Deposition Technique

Plasma-sprayed Y2O3-stabilized ZrO2 electrolyte with improved interlamellar bonding for direct application to solid oxide fuel cells

Preparation and Electrochemical Behavior of Dense Ysz Film for Soec

Effect of Pre-Sintering Treatment of Anode Substrate on the Densification and Flatness of Ysz Electrolyte by Suspension Spray

Preparation of YSZ Film by Gravity-Electrophoretic Deposition and Its Application in SOFC