Abstract:Abstract The C/C–SiC composites were fabricated by the liquid silicon infiltration method. The mechanical and tribological properties of C/C–SiC composites were assessed and compared based on different C/C densities and the carbon fiber textile architecture. The results demonstrated that the bending and shear strengths of C/C–SiC were lower than those of C/C composites, which resulted from the carbon fibers being corroded during the process of infiltration of liquid silicon. In contrast to C/C composites, the compressive strength of C/C–SiC exhibited higher values due to the presence of SiC ceramics. Moreover, the mechanical strength of C/C composites increased gradually with the increase of the C/C preform density. The tribological properties of various C/C–SiC composites showed a stable friction phase at an intermediate braking stage. When the density of C/C preforms was around 1.78 g/cm 3 , the C/C–SiC composites exhibited excellent friction coefficients (0.438 and 0.465), and low wear rates (linear and weight wear rates were 0.450 μm/time and 0.123 g/cycle, respectively). Furthermore, the C/C–SiC composites fabricated with non-woven carbon fiber needling preforms showed relatively a higher friction value and wear rate than those of C/C–SiC with PANOF integral C/C preforms. Therefore, C/C–SiC composites have been considered promising friction materials for braking system applications.

Tribological Behaviour and Mechanism of C/C-SiC-Fe Composites at Different Braking Speeds

Tribological Behavior and Mechanism of Carbon Fibre Reinforced Carbon and SiC Dual- Matrice Composites

EFFECT OF BRAKING SPEED ON FRICTION AND WEAR BEHAVIORS OF C/C-SiC COMPOSITES

Effect of braking speed on friction properties of C/C-SiC composites

Microstructure and Tribological Properties of Cu Modified C/C- SiC Composites

Manufacture and Properties of Carbon Fibre-Reinforced C/SiC Dual Matrix Composites

Wet Friction and Wear Properties of C/C-SiC Composites During Different Braking Speeds

Microstructure and tribological characteristics of needled C/C–SiC brake composites fabricated by simultaneous infiltration of molten Si and Cu

Tribological Characteristics of C/C-SiC Braking Composites under Dry and Wet Conditions

Preparation and Properties of C/C-SiC Brake Composites Fabricated by Warm Compacted-in Situ Reaction

Manufacture and Tribological Behavior of C/C-SiC Brake Composites Modified with Fe-Si Alloy

The Analysis of Friction and Wear Performance of C/C-SiC Composites

Tribological Properties of Short Fiber C/SiC Brake Materials and 30crsimova Mate

Friction and Wear Behaviors of C/C-SiC Composites Containing Ti3SiC2

Friction and wear properties of C/C-SiC braking composites

Manufacture and Tribological Properties of C/C-Sic Brake Composites Fabricated by Warm Compacted In-Situ Reaction

Tribological properties of 3D needled C/SiC brake materials

Mechanical and tribological properties of C/C–SiC ceramic composites with different preforms

FRICTION AND WEAR PROPERTIES OF THREE DIMENSIONAL NEEDLE-PUNCHED CARBON/SILICON CARBIDE BRAKING MATERIAL

Tribological Properties and Wear Mechanisms of the Couple of 3D Needled C/SiC Composite and 30CrSiMoVA

Preparation and tribological properties of C/C-SiC composites by warm compacted-reactive melt infiltration process