Abstract:Carbon fiber reinforced silicon carbide matrix composites have received considerable attention because of their superior friction behavior. In this paper, carbon/silicon carbide composites were fabricated by chemical vapor infiltration. The microstructure, mechanical properties, and the friction behavior were investigated. The carbon fiber preform was fabricated with the three dimension needling method, and the infiltrated carbon/silicon carbide (C/SiC) composites exhibited excellent shear strength. The in-plane shear strength and the inter-laminar shear strength are 85 and 27MPa, respectively. The composites show non-brittle failure behavior resulting from fiber pull-out as well as fiber cluster pull-out. The friction behavior and friction stability are significantly improved by increasing both the density and carbon content of the composites. If the density of the composite is 2.3gcm−3, the coefficient of friction measured is 0.23, the coefficient of friction stability (as it will be defined later on) is 0.43, and the liner wear rate is less than 9.3μm/cycle. Moreover, the C/SiC composites demonstrate a good friction property against fading versus several braking stops. The rapid increase of friction coefficient approaching the end of braking is mainly related to the increasing of surface temperature in a short time and the enhanced adhesion and abrasion of contact conjunctions and asperities. The friction surface is covered with wear debris including flake materials and fragments of carbon fiber. The micro-cracks and grooves observed on the friction surface are significantly determined by cyclic mechanical and thermal stresses.

FRICTION AND WEAR PROPERTIES OF THREE DIMENSIONAL NEEDLE-PUNCHED CARBON/SILICON CARBIDE BRAKING MATERIAL

3D Needle-Punched Carbon/Silicon Carbide Ceramic Matrix Composites and Tribological Properties

Microstructure and Properties of 3d Needle-Punched Carbon/Silicon Carbide Brake Materials

Three-dimensional needled carbon/silicon carbide composites with high friction performance

Microstructure and tribological properties of 3D needle-punched C/C–SiC brake composites

The Microstructure and Tribological Properties of Carbon Fibre Reinforced Carbon/SiC Dual Matrix Composites

The Analysis of Friction and Wear Performance of C/C-SiC Composites

Preparation and Friction Behavior of Carbon Fiber Reinforced Silicon Carbide Matrix Composites

Frictional Properties of C/SiC Brake Materials

Influence of Graphite on Tribological Properties of C/SiC Braking Material from Needled Felt

Manufacture and Properties of Carbon Fibre-Reinforced C/SiC Dual Matrix Composites

Wet Friction and Wear Properties of C/C-SiC Composites During Different Braking Speeds

Microstructures and Improved Wear Resistance of 3D Needled C/SiC Composites with Graphite Filler

Preparation and Tribological Properties of C Fibre Reinforced C/Sic Dual Matrix Composites Fabrication by Liquid Silicon Infiltration

Preparation and Properties of C/C-SiC Brake Composites Fabricated by Warm Compacted-in Situ Reaction

Tribological Behaviour and Mechanism of C/C-SiC-Fe Composites at Different Braking Speeds

Friction and Wear Properties of Carbon/carbon Composites with Different Martix Carbon

Friction and wear properties of C/C-SiC braking composites

Tribological properties of 3D needled C/SiC brake materials

Low-cost preparation and frictional behaviour of a three-dimensional needled carbon/silicon carbide composite

Manufacture and Tribological Properties of C/C-Sic Brake Composites Fabricated by Warm Compacted In-Situ Reaction