Abstract:The relationship between von Mises equivalent stress <math>σ¯</math> and equivalent plastic strain <math>ε¯</math> (PEEQ), termed as von Mises stress-strain, plays an important role in numerical simulations for ductile fracture of structural metallic materials with large plastic strain. The standard uniaxial tensile test on cylindrical specimens is the most straightforward method to derive the (<math>σ¯−ε¯</math>) data. However, the distribution of the stress and strain along the necking section of the tensile specimen is no longer uniform in the post-necking process, which induces difficulty in acquiring the (<math>σ¯−ε¯</math>) data. The existing correction methods to identify von Mises stress-strain in the post-necking regime need instantaneous geometry of the notched region and ignore influence of the initial geometry of the specimen, which induces these methods are inconvenient for application and inapplicable for circumferentially notched tensile specimens to determine (<math>σ¯−ε¯</math>) of each individual material zone in a hybrid coupon (e.g. weldment). In the present study, influences of initial geometry of the specimen and plastic hardening property of material on necking process are investigated firstly. It is found that the shrinking behavior of the minimum cross-section of the specimen is determined by the geometric parameter of specimen and plastic hardening exponent of materials. Based on an extensive parametric study a modified power law function to characterize the von Mises stress-strain curve from tensile tests on circumferentially notched specimens without measuring instantaneous geometry of cross-section is proposed.

Measurement and description of the stress-strain curves of W-40%Cu alloy

A study of local mechanical properties of 304L SS welded joints subjected to cyclic straining using depth-sensing instrumented indentation

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

The Yield Volume Fraction approach to the description of the stress-strain curve of a nickel-base superalloy

Co-deformation in Cu–6 Wt.% Ag Nanocomposites

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Experimental and Numerical Characterization of Low Cycle Fatigue and Creep Fatigue Behaviour of P92 Steel Welded Joint

Quantitative analysis of strength and plasticity of a 304 stainless steel based on the stress-strain curve

A study of the Cu0.95Al0.05 alloy: stress-strain curve and microstructure

Effect of Cu Alloying on Strain Capacity of Cu-bearing Pipeline Steels

Full-Range Stress–Strain Curves for Aluminum Alloys

Characteristics Analysis of Stress-Strain Curves of Metal Powers During High Velocity Compaction Process

Large strain flow curve identification for sheet metals under complex stress states

Investigation of deformation behavior and strain-induced precipitations in Al-Zn-Mg-Cu alloys across a wide temperature range

Compressive Rheological Behavior and Microstructure Evolution of a Semi-Solid CuSn10P1 Alloy at Medium Temperature and Low Strain

Modeling and Verification of Stress Relaxation Behavior of Ti-6Al-4V

Stress–strain curves of metallic materials and post‐necking strain hardening characterization: A review

Simplified method to identify full von Mises stress-strain curve of structural metals

Analysis and Modeling of Stress-Strain Curves in Microalloyed Steels Based on a Dislocation Density Evolution Model

Estimation of Mechanical Properties of Aluminum Alloy Based on Indentation Curve and Projection Area of Contact Zone

Representative Stress-Strain Curve by Spherical Indentation on Elastic-Plastic Materials