Abstract:Characterizing the behavior of ductile metals at high strains is essential in various fields. In the case of thin sheets, rectangular cross-section specimens are used to characterize these materials, typically by tensile tests. Unlike cylindrical specimens, flat ones pose additional challenges for the hardening characterization at high strains, especially in the post-necking phase, which, for many high-strength steels, may cover most of the plastic strain range. After the onset of global necking, the rectangular cross-sections tend to distort with respect to their original shape, as their edges progressively curve and bulge inward. The localized necking occurring after the global one in thinner specimens, further distorts the necked zone. Additionally, sheet metals usually exhibit anisotropic characteristics that affect the derivation of the stress–strain curve and need to be dealt with. No exact method exists for the stress–strain characterization of ductile thin sheets at high strains from tensile tests. Although several approximate methods are available in the literature, they either discard the post-necking range or require highly advanced and complex experimental setups not suitable for industrial applications (e.g., 3D DIC). Then, this work proposes a relatively simple methodology for the experimental characterization of anisotropic thin sheet metals through tensile tests on rectangular cross-section specimens that delivers the true stress–strain curve of the material, extended over the necking range and up to fracture, accurately assessing the anisotropy and the distortion of the neck section. The proposed methodology, employing a standard single-camera experimental setup, is illustrated here, referring to four different steels for automotive applications with reference to a single material orientation; it is intended as representative of the repeated procedure involving tensile tests along 3 or more material directions in order to describe the whole anisotropic plastic response. A detailed comparison between the novel methodology and four other common approaches is carried out, highlighting the differences and the enhanced capabilities of the novel one proposed.

Simplified method to identify full von Mises stress-strain curve of structural metals

A unified expression of elastic-plastic notch stress-strain calculation in bodies subjected to multiaxial cyclic loading

Stress–strain curves of metallic materials and post‐necking strain hardening characterization: A review

A New Method For Calculating Notch Tip Stresses And Strains Based On Neuber Method And Esed Method Under Multiaxial Loading

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Test-and-FE-based method for obtaining complete stress-strain curves of structural steels including fracture

A Modified Method for Calculating Notch-Root Stresses and Strains under Multiaxial Loading

Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves

Identification of Post-Necking Stress–strain Curve for Sheet Metals by Inverse Method

Fracture Prediction And Necking Analysis

An experimental investigation of large-strain tensile behavior of a metal sheet

On the Study of Stress-Strain of Thin-Walled Cylinder Tensile Specimens at High Temperature

Large strain flow curve identification for sheet metals under complex stress states

Study on Multiaxial Stress-Strain Curve with Three-Dimensional Approximate Method

A Tensile Characterization Study of Metal Sheet in Large-Strain

An Enhanced Approach for High-Strain Plasticity in Flat Anisotropic Specimens with Progressively Distorting Neck Sections

A Simplified Procedure to Determine Post-necking True Stress–Strain Curve from Uniaxial Tensile Test of Round Metallic Specimen Using DIC

Inverse Identification Method for Determining Stress–strain Curves of Sheet Metals at High Temperatures

Validation of Constitutive Models for Experimental Stress-Strain Relationship of High-Strength Steel Sheets under Uniaxial Tension

Strain measurement by contour analysis

The Structural Strain Method for Fatigue Evaluation of Welded Components: Analytical Treatment of Reversed Plasticity