Abstract:A series of nonlinear characteristics, such as strain softening, elastic–plastic coupling, and plastic deformation failure, have focused attention on postpeak deep rock masses. However, one-dimensional models, such as the Mohr–Coulomb (M–C) and strain-softening (SS) models, do not consider the influence of confining pressure, which can increase inaccuracies when used for simulating rock deformation in deep underground engineering. In this study, the composite effect of plastic damage accumulation on the mechanical properties of surrounding rock under different confining pressures was investigated through triaxial cyclic loading–unloading tests. A two-dimensional mechanical model for the cohesion, friction angle, elastic modulus, and dilatancy angle was developed by considering the combined effect of the confining pressure and plastic shear strain. The results showed that the cohesion and friction angle could be determined using an exponential function and a line function, respectively, with plastic deformation and confining pressure. The correlation coefficient of the two-dimensional function reached 95%. The elastic modulus increased with the confining pressure as a negative exponential function but decreased with the plastic deformation as a linear function. The dilation angle linearly decreased with the confining pressure and first increased and then decreased with the plastic deformation, which could be determined by the difference between two exponential functions. Through the use of FLAC3D software, the strain-softening model developed in this study was used to simulate a triaxial rock compression test, and the result demonstrated that the modified model was accurate and reasonable.

Characteristics Analysis of Stress-Strain Curves of Metal Powers During High Velocity Compaction Process

Research of Constitutive Relation of Metal Powder in High Velocity Compaction

Relation Between Force Chain Quantitative Characteristics and Side Wall Friction Behaviour During Ferrous Powder Compaction

Finite Element Analysis of Densification Process in High Velocity Compaction of Iron-Based Powder

Investigation on the Friction Mechanism and Its Relation to the Force Chains During Powder Compaction

Correlation Mechanism Between Force Chains and Friction Mechanism During Powder Compaction

Mechanical Properties and Constitutive Model of Aluminum Powder/rubber Matrix Composites Compressed at Various Strain Rates

Yield behavior of metal powder assemblages

Hot Deformation Behavior and Microstructure Evolution of High-Strength Al-Zn-Mg-Cu Alloy

Research on dynamic deformation behavior and constitutive relationship of hot forming high strength steel

Effect of Material Anisotropy on the Mechanical Response of Automotive Steel under High Strain Rates

Constitutive model for metal materials during hot deformation based on exponential equation

An experimental investigation and mechanical modeling of the combined action of confining stress and plastic strain in a rock mass

Finite-strain formulation and FE implementation of a constitutive model for powder compaction

On the Constitutive Models for Ultra-High Strain Rate Deformation of Metals

New Insight for Mechanical Properties of Metals Processed by Severe Plastic Deformation

Analysis and Modeling of Stress-Strain Curves in Microalloyed Steels Based on a Dislocation Density Evolution Model

An enhanced DPC model for metal powder incorporating yield strength of solid-state

Deformation behavior and forming process simulation of semi-solid powder rolling based on the combined constitutive model

Physical Based Constitutive Model for the Prediction of Plastic Deformation of Fe‐Cr‐Ni Stainless Steel Under High Strain Rate

High strain rate compression deformation mechanism and constitutive equation of fine grained Mg–7Gd–5Y–1.2Nd–0.5Zr alloy at different temperatures