Abstract:Metal powder compaction is a crucial process in powder metallurgy, significantly affecting the final properties of compacts. However, the quantitative characteristics of multi-scale mechanical structures and the microscopic densification behavior, taking into account the influence of friction conditions, remain unclear. This study utilises a two-dimensional multi-particle finite element method to analyse the ferrous powder compaction. The evolution of powder densification, powder deformation and multi-scale mechanical behaviour under different friction coefficient conditions are analyzed quantitatively and qualitatively. Results reveal that powder densification occurs in distinct stages, with lower friction coefficients promoting greater powder densification, as observed from relative density and coordination number. Additionally, as the axial strain increases, plastic strain gradually rises whilst roundness decreases. Higher friction coefficients are associated with higher equivalent plastic strain but lower powder roundness. The Von Mises stress exhibits different stages of increase with the increment of axial strain. Powders with lower friction coefficients exhibit lower levels of Von Mises stress. As axial strain increases, the number, length, strength and direction coefficient of force chains undergo different evolution processes. Force chains exhibit longer length, fewer numbers, lower strength and lower direction coefficients at lower friction coefficients. (c) 2024 The Society of Powder Technology Japan. Published by Elsevier BV and The Society of Powder Technology Japan. All rights are reserved, including those for text and data mining, AI training, and similar technologies.

Research of Constitutive Relation of Metal Powder in High Velocity Compaction

Characteristics Analysis of Stress-Strain Curves of Metal Powers During High Velocity Compaction Process

Viscoplastic Mechanics Constitutive Model Incorporating Void Damage for Pb/Sn Solder Alloys

Relation Between Force Chain Quantitative Characteristics and Side Wall Friction Behaviour During Ferrous Powder Compaction

Correlation Mechanism Between Force Chains and Friction Mechanism During Powder Compaction

Finite Element Analysis of Densification Process in High Velocity Compaction of Iron-Based Powder

Investigation on the Friction Mechanism and Its Relation to the Force Chains During Powder Compaction

MPFEM Investigation on Densification and Mechanical Structures During Ferrous Powder Compaction

Yield behavior of metal powder assemblages

Constitutive Modelling of Plasticity of Fcc Metals under Extremely High Strain Rates

Dynamic Compaction Behaviors of Copper Powders Using Multi-Particle Finite Element Method

Cohesive zone method based multi particle finite element simulation of compaction densification process of Al and NaCl laminar composite powders

Mechanical Properties and Constitutive Model of Aluminum Powder/rubber Matrix Composites Compressed at Various Strain Rates

Experimental and Numerical Investigation of Densification Behaviors During Powder Compaction

On the deformation characteristics of materials made by means of powder metallurgy

Finite-strain formulation and FE implementation of a constitutive model for powder compaction

Constitutive model for metal materials during hot deformation based on exponential equation

Deformation behavior and forming process simulation of semi-solid powder rolling based on the combined constitutive model

Compaction Behavior and Densification Mechanisms of CuW Composite Powders

An enhanced DPC model for metal powder incorporating yield strength of solid-state

Research on Numerical Algorithm of Constitutive Equation under High Speed Deformation in Hadfield Steel