Abstract:In order to experimentally research electrical fragmentation of rocks and plasma sterilization,we developed an LCR-triggered,multi-gap,and multi-channel switch.The short pulsed forming switch was formed by the spark switch,of which a group of ceramic capacitors of low inductance in coaxial configuration was charged by a μs primary pulsed power supply.The switch performance was tested with a resistor of 600 Ω,and was further tested by an experiment of sterilization which adopted a pulse power supply.Experimental results showed that the switch had switch-on voltage in range of 29~45 kV while its total gap distance was 14 mm;when the operating voltage was 34 kV,the averaged switch-on time delay and jittering time were 115 μs and 71 μs,respectively.In the test with the resistor,the peak power on the resistor was 1.776 MW,and the range of amplitude and the rise time of the output voltages on the resistor were 33.4~34 kV and 23~28 ns,respectively.The total switch energy loss was 8%,and the energy loss on triggered circuit was 2.163 %.After 2.5×104 shots of switching,the electrode erosion was uniform,and the lengths of the electrodes were unchanged.The output amplitude voltages on the load of continuous 20 times of switching of the spark switch in the presence and absence of LCR triggered circuits were examined.The results show that adopting the LCR triggered circuit has greatly improved the switching stability of the spark switch.

Measurement and analysis of EMF around pulsed power supplies

Measurement and analysis of radiated electromagnetic fields around the pulsed power supplies

Investigation on conductive electromagnetic pulse (EMP) effects on the breakdown of GaAs MESFET-built power amplifiers (PA)

Computation of Transient Electromagnetic Field Emission from Enclosure During GIS Disconnector Switching Operations

Measurement of electromagnetic radiation dissipation in pulse power supply discharging

Measurement and Analysis of the Electric Field Radiation in Pulsed Power System of Linear Induction Accelerator

Study of measurement techniques for strong pulsed electric field

Measurement and analysis of high speed high voltage ultrashort pulse on capacitive load

Design and Performance Analysis of Multi-gap Multi-channel Spark Switch with LCR Triggered Method

Analysis and Suppression of Common-mode EMI Using Synchronous Pulsed Compensation in Power Electronics

Method of Measuring Field Emission Current under High-Voltage Pulse

Broadband Point Measurement of Transient Magnetic Interference in Substations with Magnetoresistive Sensors

Measurement of Transient Overvoltages by Capacitive Electric Field Sensors

Strong Electromagnetic Pulse Interference Loading Method on Electrical Equipment under Operation State

Calculation Of Transient Electromagnetic Fields Generated During Switching Operation In Power Substation By The Method Of Moment And Superposition Principle

Electromagnetic Sensitivity Analysis of Radio Frequency Front-End Module in Wireless Intelligent Sensors Subjected to Nanosecond Electromagnetic Pulse

Analysis of Switching Transient Overvoltage and EMC Design of the ShengGuang-III Power Conditioning System

A Novel Approach to Measuring EMP Based on Signal Processing Techniques

Emulating Radiative Field of Electromagnetic Pulse Generator Deployed with Co-Design Capacitor under Dynamic Switching Process

Magnetic Field Simulation and Measurement of MMC Submodule under Dual Pulse Test

Simulation And Measurement Of The Transient Field Of Indirect Electrostatic Discharge