Corrosion of wire and tube of copper-bearing intrauterine device in simulated uterine solution

Bian-mei Cao,Ting-fei Xi,Yu-dong Zheng
DOI: https://doi.org/10.3969/j.issn.1673-8225.2009.29.020
2009-01-01
Abstract:BACKGROUND: Copper-bearing intrauterine device has a good contraception effect involving in release of copper ion in the simulated uterine solution. Therefore, the corrosion of copper directly relates to security, efficacy, and long-term application of copper-bearing intrauterine device. OBJECTIVE: To investigate the corrosion of tube and wire of copper-bearing intrauterine device in the simulated uterine solution. DESIGN, TIME AND SETTING: An in vitro observational study was performed at National Institute for the Control of Pharmaceutical and Biological Product and Electron Microscope Laboratory of Beijing University of Science and Technology from October to December 2008. MATERIALS: Copper-bearing intrauterine device (TCu380A and TCu220C) was provided by Tianjin Medical Apparatus and Instruments Factory. METHODS: Copper wire and copper tube of the same surface area were dipped in the simulated uterine solution which was changed in regularity. Surface morphology of samples was observed under scanning electron microscope before dipping, and at day 10, 30, and 60 after dipping. MAIN OUTCOME MEASURES: Surface morphology. RESULTS: Draw trace was observed on the surface of copper wire, which in some extent contributed to the burst release of copper-bearing intrauterine device (TCu380A). While in the initial immersion phase, pits appeared on the surface of copper tube and increased the copper surface area. So cupric ion release rate of copper-bearing intrauterine device (TCu220C) increased firstly and then decreased. CONCLUSION: There was significant different in surface morphology between copper tube and copper wire in the simulated uterine solution in an early phase. For example, uniformed and dense small pits were distributed on the surface of copper wire, but irregular and large pits were distributed on the surface of copper tube.
What problem does this paper attempt to address?